How to Replace Rear Brakes 2011-2014 Hyundai Sonata

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@jg7038]

at 1:00 mark, those little bits of info are what make a great teacher. Most guys would just say "yeah we usually dont reuse them" but never tell you why. Knowing that its just something they use along the assembly line before the wheels and lugs are put on gives ease of mind when trying to get them out because you know for a fact they aren't needed again. So you can strip them out no worries

[@jimrossmeissl2726]

Damn, I just did this job. This is the first video I’ve seen where you don’t have to remove the lower control arm.

[@davearnold731]

This was an amazing video and what a great thorough job. This is why you need to work on your own car. Pay a mechanic to do this job at ANY price and he will not do half of these steps.

[@johnholland3207]

Just did this job today. I was able to take the bolt out without removing the control arm. Much easier I believe. You can tell when it is loose. Then you just carefully use a pry bar and off the caliper pops. You have to have patience. I used a 14mm box end wrench and then switched to needle nose pliers to loosen the bolt. Good Luck!

[@Toy_Checker]

Why is he opening the bleeder to push the caliper back????

[@adisharr]

Great video - extremely helpful! I ended up removing the control arm bolt since I couldn't get the rotor off otherwise.

[@davidshastry8692]

This is amazing. It's so obvious but I didn't even think about using a wrench to get to that stupid bolt. Always partially took off the control arm which was a pain. I'm due for brakes so will definitely try this. Thanks guys!!

[@josephmicciulli3034]

Thanks for this,,What is the torque of the slider ons?

[@spatel3418]

Great Video with time saving tips. Just finished my brake job following this video and saved effort and time. Thank you.

[@rebel0064]

Sir what spray did you use to clean the excess break fluid of the caliber .. hopefully I worded the question properly

[@sleepy1760]

When doing Brake just buy a CV Clamp for the Calliber you should not open the bleeder screw you could get Air into your System

[@Twil2002]

12mm for the caliper bracket bolts?

[@carwashsoap]

How do you remove the lower bolt without removing the control arm??

[@whikade6353]

Really good video! I'm heading out to the garage to do this. Thank you!

[@wayneberk1077]

Man your the best

[@aserrano4127]

Do you have to bleed it every time you push back the piston?

[@elmerbald143]

Great video..thanks

[@jasciguy1966]

Can you do the brakes on my Sonata? :)

[@evensmoise5670]

He’s awesome 🎉🎉

[@MuhammedSankanu-313]

Thank you 🙏🏾

[@TheAirwolf69]

thank you amigo 👍

[@aaronweiland4128]

45 mins later the rear rotor is off