How to replace Shock & Spring Assembly 1997-2001 Honda CRV

Buy Now!
New Shock & Spring Assembly from 1AAuto.com trq.video/ia-1...
New Shock & Spring Assembly Set from 1AAuto.com trq.video/ia-1...
This video shows you how to install a new shock and spring assembly designed specifically to fit your 1997-2001 Honda CRV. A shock and spring complete assembly simplifies installation. You don't need to separate the spring from the shock absorber.
This repair was done on a 1999 Honda CR-V EX 2.0L Sport Utility 4-Door 4WD and the process should be similar on the following vehicles:
1997 Honda CR-V
1998 Honda CR-V
1999 Honda CR-V
2000 Honda CR-V
2001 Honda CR-V
Tools you will need:
• Pry Bar trq.video/oAY-...
• 17mm Wrench trq.video/oDt-...
• 14mm Socket trq.video/oaEb...
• 17mm Socket trq.video/oaEb...
• 19mm Socket
• Trim Tool Set trq.video/oIR-...
• 1/4 Inch Ratchet trq.video/oast...
• 3/8 Inch Drive Ratchet trq.video/oaEb...
• Torque Wrench trq.video/o6g-...
• Gloves trq.video/opp-...
• Safety Glasses
Subscribe: / @trq
Check out our playlist:
Honda CR-V 1st Generation 1997-2001: • Honda CR-V 1st Generat...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@stevejohansen5373]

Thank you so much for this video you just saved me way too much money at the shop!!

[@chrisingram6475]

Great video, going to make sorting mine a lot easier, thank you 👌👌👌

[@Guaranteed_JET]

thanks so much for doing these vids

[@yamatomusashi1412]

No need remove stabilizer links connection ?

[@galenwilcox4657]

Be aware the bolt tends to bind in the lower bushing of the old strut. Ended up having to cut mine out. New parts go in great though.

[@andretablang5983]

What are the spring rates at? Are they matched exactly to oem spec?

[@mosesmutale8278]

Can the spring coil for RD1 fit RD5?