How to Replace Tail Light 2003-2021 Chevy Express Van 3500

[@Johnsurdi]

I just found a much easier and faster way to do this. simply remove the 3 10mm nuts, gently pull back on the lense cover to loosen it. Use a flat head screw driver and "gently " pry the lower end of the lense cover where it pivots on the door hinge top. Push up on the lense at the same time. It will pop off the pivot point, swing it out gently and remove the upper socket. replace the bulb and reverse the steps. much easier!!!

[@Wisconsin4eyes]

Finally a shot of the factory jack installed.

[@dan3510]

The hole purpose of this video is defeated by not addressing those push clips and how to properly remove that blank panel

[@nellaob4229]

Great video! just curious... did you find that you had forgotten to install that 1 upper right headlight nut Before you reinstalled the upper black cover? Thank you for this video.

[@borjafat]

How do you reset the blinking speed?

[@Bobbles918]

The PROBLEM with these is freeing the clips on the trim piece without breaking them. POOR job of finding the right example in this video

[@russellaustin8731]

Cool

[@josephhollingshead1848]

Thanks video was not helpful at all I was trying to figure out how to do it without breaking the clips

[@joeybilderback6597]

Not helpful at all seeing as all your stuff is broken

[@vettle1]

Proof Chevy is junk.