How to replace the clutch on a 1991-2000 manual ford ranger step by step

Replacing the clutch on this 94 ford ranger 5 speed manual, 1991-2000 are all the same transmissions the m50d-r1. Step by step how to

[@gettinit01]

Nice job man, just like the back of your hand 🎉🎉🎉❤

[@Ryans_Rural_Living]

Im not a mechanic but ive always worked on my own stuff, ive had 2 rangers and 2 explorers from that generation and replaced a trans or a clutch in all of them so ive done it a few times 😂 takes me 5 hrs in a driveway to replace the clutch on this thing while filming 😂

[@zethpatterson5060]

God send!

[@AceBase5]

What size bolts are for the bell housing

[@Ryans_Rural_Living]

13mm head, so it should be m8 bolt, theres 2 different lengths not sure the size

[@luiszar3085]

Señor esta bien fuerte esa cosa me mata si la cargo.

[@JSFGuy]

Oliver klozoff...

[@CHAOS.TV91]

please if u dont have it back in yet make a vid of ittttgoing back in i cant get mine lined up transmission wnt slide all the way on

[@Ryans_Rural_Living]

Its back in sorry, it is a total pain to get these things lined up going back in, if you dont have a a tranny jack like me youll need a second person to help for sure, some times you gotta spin the shaft at the back of the trans while wiggling it up and down and back and forth to get the splines to line up. Once you get it far enough the dowel pin lines up and is started it can be hard to push in too so you can start a few bolts and slowly and carefully tighten up the bolts to draw it in

[@CHAOS.TV91]

@@Ryans_Rural_Living me and my buddy he’s a diesel mechanic he replaces semi truck trannys all day for his job and we have about a half inch gap from the tranny and motor it just won’t slide the rest of the way on