How to Replace Transmission Mount 2001-2006 Chevrolet Silverado 2500

Buy Now!
New Transmission Mount from 1AAuto.com 1aau.to/ie/1ATMT00077
This video shows you how to install a new made to fit TRQ transmission mount on your 2001-2006 Chevrolet Silverado 2500. Like many other load bearing parts on your vehicle, the transmission mount contains rubber bushings for smooth, comfortable driving. And like other parts, the rubber bushings can wear and rot over time. It’s a good idea to replace them when that happens.
This process should be similar on the following vehicles:
2001 Chevrolet Silverado 2500 HD
2002 Chevrolet Silverado 2500 HD
2003 Chevrolet Silverado 2500 HD
2004 Chevrolet Silverado 2500 HD
2005 Chevrolet Silverado 2500 HD
2006 Chevrolet Silverado 2500 HD
Tools you will need:
• 18mm Wrench
• 15mm Socket 1aau.to/oaVM/1AXAA00015
• 18mm Socket 1aau.to/oXA/1AXAA00043
• Ratchet 1aau.to/obac/1AXAA00016
• Socket Extensions 1aau.to/oaVM/1AXAA00015
• Torque Wrench 1aau.to/oagu/1AXAA00044
• Floor Jack 1aau.to/oMJ/1AXAA00068
• Jack Stands 1aau.to/oJP/1AXAA00065
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@johncallender8032]

Hey Guy's. You do not have to remove the cross member at all. Remove your two 15mm. Nut's from the bottom of your transmission mount. Place your floor jack just behind the cross member using a small piece of 4×4 block of wood and jack your transfer case up and remove the two 15mm. Bolts from the mount. Lift the mount outta the cross member. And bolt the mount to your tranny. Leave your jack down until the 2 tranny mount stud's will drop right into your cross member. Put your 2, 15mm nut's up through the hole's in your cross member. Tighten up and your done I done mine today within 1/2 hour. Remember? You don't have to do the extra work removing your cross member. I've also have done this with cars. Not removing the cross member. Bry doing all that the Auto repair shop's are making more money from you.😊

[@merrkyonthabeat688]

Thanks for the video it helped me replace my mount and crossmember

[@armandoanaya3140]

What are those 2 tubes called right above the crossmember bolts?

[@MalikWong]

so if i do it at home, all i just need is a jack lift right? what holds the transmission and transfer case in place and not falling?

[@JADEYWADEYMAKADEYPATADEY]

Does this applies for the 4l80 also?

[@justinadams159]

This video just made me $200