How to Replace Wheel Bearing 2001-2005 Honda Civic

Buy Now!
New Wheel Bearing from 1AAuto.com 1aau.to/ib/1ASH...
This video shows you how to install a wheel bearing on your 2001-2005 Honda Civic. Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision.
This process should be similar on the following vehicles:
2001 Honda Civic
2002 Honda Civic
2003 Honda Civic
2004 Honda Civic
2005 Honda Civic
Tools you will need:
• Flat Blade Screwdriver 1aau.to/oe/1AXA...
• Phillips Head Screwdriver 1aau.to/oe/1AXA...
• Pocket Screwdriver
• Pry Bar 1aau.to/oc/1AXA...
• 19mm Wrench 1aau.to/oe/1AXA...
• 1/2 Inch Impact Socket Set 1aau.to/od/1AXA...
• 1/2 Inch Impact Socket Set 1aau.to/od/1AXA...
• 10mm Socket 1aau.to/oe/1AXA...
• 12mm Socket 1aau.to/oe/1AXA...
• 17mm Socket 1aau.to/oe/1AXA...
• 19mm Socket 1aau.to/od/1AXA...
• 32mm Socket 1aau.to/od/1AAS...
• Bearing Puller
• Dead Blow Hammer 1aau.to/od/1AXA...
• Hub Puller
• Press
• Pliers
• Snap Ring Pliers
• 1/2 Inch Air Impact Gun 1aau.to/od/1AXA...
• Ratchet 1aau.to/od/1AXA...
• Torque Wrench 1aau.to/od/1AXA...
• Bearing Grease
• Gloves 1aau.to/oe/1AXS...
• Safety Glasses 1aau.to/oe/1AXA...
• Sandpaper
• Chisel 1aau.to/od/1AXA...
• Hammer 1aau.to/od/1AXA...
• Rubber Mallet 1aau.to/od/1AXA...
• Small Hook
• Wire Brush 1aau.to/oa/1AXA...
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@Josephg.1993]

Where can I get the bearing tool for this job at?

[@joshcantrell8397]

I love how smoothly you’re able to remove parts in your videos lol. Just spent 15 minutes trying to get my seized ball joint loose🤗🤗🤗

[@businessraptor134]

Pro tip clean and grease your caliper bracket slide bolts for longer pad life. You can also freeze your new bearing for a few hours before pressing it in if you have the time. It will shrink and should press in easier and be less likely to jam being pressed in. U joints and ball joints almost fall in in comparison.

[@kirkpatterson4037]

I like the video. You never put high heat lube on the brake pads where they slide. You should mention to check and clean caliper sliders, check caliper to make sure piston goes in easy so you can have room for new pads. All good. My buddy did what you did but sliders were sticky and he had a problem putting new pads in. He was trying with out pressing incaliper piston. He was also forcing in a siezed piston. Good thing i caught him so he could check everything before completing this.

[@peterandkodiak9762]

You Sir are a Pro! This video has excellent content! Well done! A+

[@josediaz8994]

Lovet ,AWESOM ... GOOD QUALITY VIDEO ...LOOKS VERY CLEAR ...THANKS GUYS FOR SHARING.

[@TRQ]

+@josediaz8994 Thanks for the feedback! 1aau.to/m/Shop-TRQ

[@nathanielschell9059]

Is it okay if the hub you installed after the new bearing wiggles in the bearing ? I haven't torqued the axle nut yet and the bearing sits tightly with the c clip installed. I just put two new bearings in and both of them had the same problem.

[@luistrevino6229]

Fantastic video !!!

[@Adrian-tk6jc]

We're you get the press that you use for with the wrench gun?

[@obee69242000]

Which direction does the bearing go I have 02 civic ex with abs

[@nationalgigugraphic]

감사합니다

[@dillonblankenship1292]

What snap ring pliers. I can not get the clip in to save my life