How to Set an Unloader Valve (Pressure Regulator)

[@jeffthomas7383]

Just replaced stock pump and this was exactly the info I needed to get it adjusted correctly. Thanks!

[@spencerknight3338]

Best video i could find on adjusting a unloader. Good info and easy to understand. GREAT JOB.

[@Spraywell]

+Spencer Knight Thanks, glad we can help.

[@MrSmartass89]

Excellent video. No BS and straight to the point. Doesn't get any better than that.

[@l-skywalker-l2081]

Great vid dude !

[@MrROLLOXXX]

Great video bro

[@dianasahlbergextremecleanp9946]

Great video and explanation. Thanks! .

[@FairyCatGrace]

Nice video!

[@UnderPressurePowerWashingLLc]

David Zabala Better Then Most ! Nice work.

[@UnderPressurePowerWashingLLc]

Nice video, Helpful Information!

[@owenbarnhart5771]

Awesome info well done !

[@PhilGz]

Good video, thanks for info :-)

[@Spraywell]

thanks! Glad we could help.

[@DustyDawnaDigsHistory]

Excellent .... 5⭐

[@mperez27]

I have a 4000 psi @ 4 gpm and I get 4000 psi when I release handle but when spraying I only get about 3300. I have a 4.0 nozzle on the end and not sure what else I can do to raise the pressure...any advice?

[@Spraywell]

+mperez27 The highest pressure you want WHILE holding the trigger will be 3500 - 3600 psi, you just need to set your unloader a little lower by lowering the 2 locking screws as shown in this video.

[@UnderPressurePowerWashingLLc]

Educational Video. 👍

[@MAGTRAIN]

great. thanks

[@MrROLLOXXX]

I have a economax em15-p 4000psi @4.0GPM, with the 0 degree nozzle the psi go to 3200-3300psi... I need to do your process for to obtain at least 3700-3800psi pulling the trigger?

[@Spraywell]

most likely

[@843geechie7]

Ok I toke my unloader off. Now I hear a ball moving around. Is that normal?

[@LawrenceL1000]

If you don’t know....now you know!