How To Set CNC Offsets In Mach3 After Setting Your Soft Limits..

[@mattwilley5852]

If you set your bit with the offset ,then on the bed while the bits in the spendel you can put a collar on the bit and do that with all your bits and put number put them in under different settings that how I use the offsets. When I use the same substrate for the job. Then when I set a another job I set all my dits in the offsets and all of my bits in er20 c and bits already to go all got to is hit button

[@corvetteguy50]

Matt, thank you for your support, and your absolutely correct with that wonderful idea. This is the "Holy Grail" of becoming super efficient. I hope everyone watching the video reads this comment! Thank you, Vince

[@shelby50411]

Great video corvette Msybe you csn help me with other issue...is there s way to disable or reduce current to stepper motors when are idle. Using mach3?

[@corvetteguy50]

H S thank you for your support. Unfortunately this isn't possible through Mach3. Thank you, Vince

[@michaeldague3578]

My CNC controller was recently changed from an ethernet connection to USB by build your cnc due to a driver and the BOB going out. Since I got it back it has not worked right. I did load my xml into mach3, I had the machine coordinates at the front right of the machine, I would place my work piece on the table, set to work coordinates over the piece and it worked fine. now I cna't get the machine coordinates to the front/right and my work pieces show off the table. Any suggestions?

[@corvetteguy50]

Thank you for your support. I would recommend removing Mach3 after copying your settings, and license then reinstalling it. Thank you, Vince