HOW TO: SKT GRILLE LED KIT INSTALLATION | 19-24 RAM 1500 DT

[@danielproa4931]

What size wheels and tires are those?

[@crazyfly01]

I’ve been waiting for this thank you

[@jarretwaldman3685]

What offset are those wheels

[@MFW1996]

How is the ecodiesel performing with the lack of airflow across the intercooler?

[@vicedesigninc]

Just fine, we ran this kit throughout the entire summer and didn't notice a difference.

[@MFW1996]

Good to know, thanks.

[@richardcruz8117]

I’m ordering it 💯💯💯

[@Jr-eu9ex]

The Baja squadron pros take up more Wattage… do I just add a bigger fuse to the aux beam? Also, if I were to order your pre made harness will it come with female end douch connectors?

[@vicedesigninc]

The squadron pros are 41 watts so a bit over 3 amps each. We run the centre three lights on one harness and the outside 2 on another. There are two 20A ports on the 8 gang auxbeam that will be more than sufficient. Our harnesses come with male deutch connectors, which fit most lights. The baja designs lights use a different connector, we’ll look to come out with a compatible kit.

[@Jr-eu9ex]

@ gotcha! I’m not super familiar with electrical stuff. Just to double check I can hook up three lights to one 20A port and the other two to the other 20A port correct?

[@vicedesigninc]

@@Jr-eu9exno problem - happy to help. So the three lights will draw 10 amps. To safely size the fuse correctly times that by 1.25, which gives us 12.5A, so the 15A fuse port will be good. That leaves you the 20A circuits free for a larger accessory draw

[@Jr-eu9ex]

@@vicedesigninc oooh okay that makes sense.. now I have an excuse to make an un necessary purchase to use one if not two of the 20A slots 😆 Thanks again for the info and replies!

[@djtayer3151]

What size are those spacer/washer for the brackets?

[@FatBlueLine6217]

Id love to see these in operation.

[@collinglasscock3015]

How do those lights perform at night and how far does the beam go?

[@crazyfly01]

was gonna place a order today? I’m just wondering. On the pods is there room for adjustment to make them flush with the grill using washers?

[@crazyfly01]

I just watched the video again and I think I answered my own question. I don’t think you can do it with those pods

[@vicedesigninc]

@@crazyfly01 yeah how they sit in the video is how they sit, which is a bit recessed from the front of the bumper. The Baja design 3” pod lights fit recessed more but they are about twice the price.

[@darrenyorston]

That lower grill segment where the sensors are fitted is solid, no hole, in my 2022 DT 1500 Laramie.

[@vicedesigninc]

The Hemi powered trucks are solid, the Eco-diesel powered trucks have openings between the webs

[@darrenyorston]

@ I’m in Australia and bought your sunbeam mount recently. I like this light grill design. When the wife isn’t looking I might buy one.