How to use a HUSQVARNA K4000 EL 14" Disc Cutter

General safety instructions
• You must not repair the product unless you have
read and understood this workshop manual.
• The product is examined and approved only with the
equipment given or recommended by the
manufacturer.
• Service personnel must make sure that the service
and repairs in this manual are done following legal
requirements. This in order to avoid health and
safety risks of the personnel doing the work.
• When possible, disconnect the power cable and
make sure it cannot be connected until the service is
completed.
• If you keep the product running during service, do
not touch the wires. Electrical shock can cause
injury.
• Follow the local waste regulations.
• Always make sure all nuts and bolts are correctly
tightened.
• Do not lift the machine by holding the cable and do
not pull the plug by pulling the cable.
• Check that the cables are not damaged and in good
condition.
• Do not use the product if a cable is damaged.
• Use protective gloves and eye protection. Goggles
must follow the ANSI Z87.1 for US or EN166 for EU
countries.
• When using compressed air, do not point it to your
body. Air can go in to the blood stream.
• Wear ear protection when test running.
• The product can make sparks and cause ignition of
flammable materials.
• If a warning symbol decal on the product is
damaged or missing, replace the warning symbol
decal.