Husky no drill Mud Guard Installation 2018 Ford F 150

[@axlsavage]

I just did mine on a 19 XLT. You are right, fronts are a pain but the rears were easy. But it was worth it. They look great! Great vid! Thanks

[@dirtpoortv4483]

Thanks for watching Dirt Poor Tv

[@scottdowney4318]

I just installed Husky on my 2005 Rm 3500 Dully on the front. You can not drill the plastic without removing the tire, BUT you can heat up a nail with a torch and melt a hole with the tire on the truck. Worked well.

[@dirtpoortv4483]

Great idea! Thanks for watching Dirt Poor Tv.

[@Ahmad-yw5hl]

Thank you from the bottom of my heart. You saved me

[@jeffreydavis8838]

I bought these for my 2019 F-150 with OEM fender flares. I think the instructions provided by Husky are a little inadequate. I like this video in that you show the issues that can occur and the extra steps that may be needed to make the flaps secure.

[@dirtpoortv4483]

I do like the Husky mud guards fit and finish. But the install is a pain in the a**. Thanks for watching Dirt Poor Tv.

[@dootdeedootdeedoo]

Just did this install on my 21 xlt and I have to say this is the first time I hated a mod. Hope they hold up but for how highly recommended the came from a coworker I feel bad doing this to my new truck.

[@dirtpoortv4483]

Mine have held up through a Illinois winter with no issues. Thanks for watching Dirt Poor Tv

[@scottdowney4318]

On my Ram, was no way to tell which end of the plastic goes up. Nothing in the generic instructions. What I did was put the thinner part at the top, and where it curves out like a fish belly, that went towards the rear. Frankly, I doubt many people actually get the plastic on in the right spot, i still can't say for certain I did either.

[@scottdowney4318]

big problem with this infomercial is the clips installation. Cant see anything you did or how.

[@dirtpoortv4483]

At 11 minutes in the video I am showing you how to install the clips. It is hard to see because my back is covering the camera. You basically put the clip over the mud flap and over the body molding and push it on. It has teeth on it that grabs onto the plastic. Sorry it was hard to film that angle but you should get the picture.Thanks for watching Dirt Poor Tv

[@scottdowney4318]

@@dirtpoortv4483 You nailed it at the end of the video calling it a terrible installation process. I am getting ready to put on the Husky flaps 57071 on my rear dually. I got them cheap at $40 from Ebay as hardware was missing. I have full plastic inner fender liners and plan to use 4 #12 long screws with big washers. they secure all along the curved fender edge. On my Ram 2005 dually, the dually fenders are a type of plastic, so no concerns about rust. Instructions say use #10 screws, but I already have plenty #12 from a different project. I also figure a slightly bigger screw can hold them on better.

[@marvinelder3828]

Husky makes nice looking mud flap, but look to be labor intense. I was also looking at WeatherTech mud flaps. I also have 2018 ford f150xlt. Not sure which way to go. Pro's and cons to both brands.

[@dirtpoortv4483]

I have never had the WeatherTech mud flaps but yes the husky are labor intensive. If I were you I would give weather tech a try. If you are not worried about the installation husky mud flaps look and get the job done.

[@akfury83]

Oem ford molded ones are bullet proof.

[@kaden1499]

Is yours considered the ones with or without flares?

[@dirtpoortv4483]

These are the ones for factory fender flares. Thanks for watching Dirt Poor TV

[@jeffreydavis8838]

Are those specklebellies in the background?

[@dirtpoortv4483]

At what time slot in the video?

[@jeffreydavis8838]

@@dirtpoortv4483 you can hear them off in the distance starting at 14:15. The crescendo is at 15:30.

[@dirtpoortv4483]

Yes that was a large flock of Canadian geese flying overhead. They congregate in the fields around my house. You have good hearing I never even noticed because it is normal around here. Thanks for watching Dirt Poor Tv don't forget to hit that subscribe tab.

[@lastpme]

Those clamps are awful. I did drill it out to secure the flaps.

[@dirtpoortv4483]

Yes they are junk clamps.I have also had to put screws in the other designated spots because the mud guard was making my trim piece come lose on both sides from flapping in the wind. Thanks for watching Dirt Poor Tv.