HVAC CONTROL BOARD...

The control board is the brain of the HVAC unit.. In this video i will show you how to determine if your hvac/Heating furnace/cooling unit control board is defective..
#yorkhvac #hvac #d2dnyac

[@syedbasheer8210]

Nice explanation..🤩

[@D2DNYAC]

Thank you 🙂

[@jeffcronk8572]

Good job in the big city!

[@D2DNYAC]

Thanks for stopping by

[@abdullahkhan6333]

good content (explanation is excillent)

[@D2DNYAC]

Thank you for stopping by

[@heatingairservices8708]

Thanks new Subscriber here ..but with 30 + yr in Res service & Installs & some light Commercial installs yrs ago but & Now Com Service ....Theres A lot the commercial HVAC boards are or can be complicated unless specifically trained on those type boards & this Video helped me a lot ..Ima currently working .on an york 300k gas pak roof top iam having issues with stage 2 heat drops out but Board throws NO Code ..Its heat 1& 2 fine when iam on Site & still there testing there.... but looses sage 2 over nite .....so right now Iam Stumped - ill Study Up & Go Back Tomorrow Thanks Again

[@D2DNYAC]

Sounds like main controller not putting out for second stage

[@lawshop4404]

I have the same Simplicity control board on a 12-ton York cooling only unit that cools a server room. No problems with the board so far but I've noticed that when you reset the power to the unit, the display shows some weird characters. It does start the unit normally after a couple of minutes. How often do you see them fail? Thanks for sharing the video.

[@D2DNYAC]

I don’t work on these frequently so I don’t know if any trending issues!

[@sdsd4284]

Love ur videos, hope all is well with u men haven't seen u release anything in a while hope u just busy .

[@D2DNYAC]

Thank you 🙏I am okay my friend… but also very busy I also have several videos in the cue so stay tuned and enjoy the shorts

[@prithwishdey6708]

Please discuss plc programming and cannection in hvac.

[@D2DNYAC]

AUTOMATIC DOMESTIC WATER BOOSTER PUMP CONTROLS PANEL BUILD PART III

[@D2DNYAC]

PLC videos.... LEAD LAG BOSTER WATER PUMP CONTROLS PANEL BUILD PROJECT

[@D2DNYAC]

kzbin.info/www/bejne/ramkp6mrnK98nNk

[@mark.r8900]

my york rtu unit is in heat mode and giving a HS1 limit switch error on the smart simplicity control. I've checked the high limit switch and it seems fine. The manual for the control says the LS1 has tripped 3 times within an hour. This results in the HS1 LIMIT SWITCH LOCKOUT. Any help would be greatly appreciated. Thanks.

[@D2DNYAC]

Limit switch tripping!! depending on the Limit it's either a overheated heating chamber or a flame roll out or potentially a bad Limit switch

[@allisonm4086]

I actually work at the York factory. I test the units before they leave the assembly line. If you know can tell me the model of your unit I could definitely give you some helpful troubleshooting tips.

[@mark.r8900]

Model#: ZE036H10B1A1AAA1A2 Thank you.

[@mark.r8900]

Also on several occasions the unit locked out and gave an error saying "frozen coil". Even when it was running in heat mode.

[@D2DNYAC]

Interesting 🧐

[@SombraLocs]

How do you reset any alarms?

[@D2DNYAC]

simply power cycle the unit

[@ashwinprasla917]

york return air humidity sensor failure.what to do?

[@D2DNYAC]

Try replacing the sensor

[@bobbyhill605]

What it means the lights are off no lights at all

[@D2DNYAC]

No power, bad low voltage transformer, blown fuses and last but not least bad board

[@roqueherrera8471]

Juice baby…..😂😂😂😂😂😂😂

[@D2DNYAC]

😊thanks for watching