Hydro-boost Assembly Installation Quick Tips

The following video from MPA provides important tips to follow when installing a hydro-boost assembly.

[@dwightjtaylor]

Fully informative the old school way.

[@roypurganan5839]

The part's store took my original plunger off my hydro boost do you know where I can get a plunger for my 98 k2500

[@salascarlosgerardo6070]

Thanks a Lot by share this clear and useful information. Beside that, please let me know how can I get specificy information ( Electro - hydrbooster system) about GMC Topkick 1996?? Your help is well appreciated.

[@fernandocastorena6381]

Nice thanks 🙏

[@jammerp226]

Great explanation!

[@authorityrecordco]

Great video, with Great information!!!

[@henrydixon3159]

Great video I just installed my new hydroboost system and I have 2 lines leaking on the low pressure side is there any kind of o- ring that I should have used any help would be great

[@JLE1177]

They came with the new one

[@mblake0420]

I installed a hydroboost and my brakes are locked up. Is it bad? Seems like it's pushing on rod when tightening the nuts

[@alrodriguez3345]

great work on this video

[@priyavartswami7851]

I am replace the 2003 mustang hydrobooster seal and fix it , pedel is very low down , after start the engine pedel same , what is the problem

[@kainhall]

You don't know what you are doing... That's the issue . What is an "engine pedal"??? Gas pedal.???

[@klumsytone]

@@kainhalllmao

[@daddyphatsax304]

Assembly instructions?? Must've missed those...

[@JudyLBrock]

what brand of power steering fluid can i use . is it only Gm fluid

[@kainhall]

Use ATF.... whatever your trans uses . Gm doesn't have a "gm only" PS fluid Just dextron 3(or 6) And normal "power steering fluid" are both OK . Dodge MUST use atf+4

[@franciscochavez5648]

Cómo purgar después de remplazar todo Gracias espero y me conteste 🙏🏻

[@matthewkellum]

how do i find a replacement push rod for master cylinder

[@gogaston]

I'm researching a solution for this. please email me @ [e-mail]

[@marks2964]

We found this kit online and it worked perfectly for us. If you remember to take out the parts from the original unit you wouldn't need this. I will remember this next time. www.ebay.com/itm/223816807969

[@edpagan5421]

what truck is that?

[@jimmysapien9961]

Interesting 👍🏻👍🏻👍🏻

[@jsburke5]

Good info, but if you're skill set isn't at least to this level, you shouldn't be doing this type of maintenance

[@jimdonbrock1668]

Pointing out the obvious, no real useful information.

[@azizshavershian2065]

shut up beta

[@vacayooper4728]

But you watched it

[@souliog]

I disagree…I learned that you can keep master cylinder and lines intact as well as the bleeding of power steering afterwards