Hydrostatic Level Sensors

Check out this recorded webinar about Hydrostatic level transmitters, and let us know if we can help you out with options for your process or solution requirements.
Email us at [e-mail]
Call - 03 343 0646 (Christchurch) or 09 827 1930 (Auckland)
www.intech.co.nz
Hydrostatic level transmitters are designed to measure the level of clean or contaminated liquids.
The pressure sensor at the bottom of the probe measures the hydrostatic pressure of the liquid column above it and compares with the atmospheric pressure. The atmospheric pressure is led to the sensor through a breathing capillary built into the cable.
This enables the atmospheric pressure to be subtracted from the measured pressure to get the hydrostatic pressure which is proportional to the height of the liquid column. The electronics converts the sensor’s signal into an output signal.We have excellent stock of Hydrostatic Level Transmitters from multiple specialist suppliers including Jumo, Nivelco and the Intech LLT.
Intech have Level Transmitters for a number of various applications such as clean water, through to viscous sewage / slurry and Diesel.
Accessories include:
• NAA-101, Terminal Box with filter.
• NAA-209 Hanging Cable Clamp.
• Pressure equalization filter for cable.
We strongly recommend that overvoltage protection device(s) are used with the Transmitters if long runs of cable are involved in the Installation.
These protect against potential Lightning strike or earth potential rises.
We offer two solutions for this:
• NAA-102, similar to NAA-101 but with integral Over Voltage Protection in-built.
• LPN-OVP, DIN Rail mounting at the control board end of circuit.
Credits:
Presented by - Craig Bennett
Content Editor - Andrea Velandia
Video Editor - Laura Brown

[@JZ-Sensor]

thump up

[@DilshadAhmad-zi9iz]

THANKS very informative

[@SolomonSAK]

Interesting

[@souridhbanerjee2351]

can i get the ppt??

[@anubhabpanigrahi3279]

Can it be used for hydrodynamic load?