I Bought a $26 Crf50 Top End Kit on Amazon So You Don't Have To!

[@GarageAddiction]

As an update on this, the cylinder is also trash. The dowel holes are bored too deep, the threaded hole to attach the head was misaligned, and the hole to attach the cylinder to the case was misaligned.

[@Lorenzo-yg6hn]

Nice video 💯

[@GarageAddiction]

Thanks!

[@Tuckem2STOGS]

You have link I got a 39 $ one dose not have the writing on cylinder tho I'm going to give it a shot

[@GarageAddiction]

amzn.to/3yHb8Xj Makes a sweet paperweight lol

[@Tuckem2STOGS]

@@GarageAddiction Copy www.amazon.com/dp/B016HLZATG/ref=cm_sw_r_sms_awdb_imm_VSDZX5FQPPNT36T3PQX4

[@Tuckem2STOGS]

This is what I ordered

[@Tuckem2STOGS]

@@GarageAddiction the cylinder was not to bad just glazed piston looked not bad either I can send u pic fb msg if u wanna see debating on Trying to make it work I got a whole gasket set it should be in today From our local dirt bike shop I'm wondering if I should hone the original cylinder the bike ran fine ran fine just had 36PSI compression yes I compression valves seats are good

[@GarageAddiction]

@@Tuckem2STOGS check the wrist pin fit in the piston and the alignment of the cylinder on the bottom end with the bolt on the left side, those were the two biggest issues. The dowels also fell into the cylinder much further than usual when I was fitting it up. I honed an oem and slapped it on instead of the cheap kit but it's a different seller so it may be decent.

[@TheBig21kc]

Hey bro did u finish your daughters bike ? I’m doing the same thing for my son

[@GarageAddiction]

That's awesome, I'm sure he's going to love it. This top end was meant for her bike but I ordered another which should be in tomorrow. Hopefully have the majority of the bike together then!