INAV and tail sitter VTOL support

[@MCsCreations]

Sweet! Thanks, Pawel! 😊 Stay safe there with your family! 🖖😊

[@LalitSingh-ul6ii]

Sir, INAV 7.1.1 version has also been released but the mixing of VTOL plane has not come yet

[@TheCatFather01]

Amazing work, thank you!🙏🏽

[@jj-avi]

Currently building a standard VTOL. Fixed Quad Drive and Puller motor for Fixed wing. Hope INAV 7 will handle it fine. I haven't seen any videos on such a configuration, only tilt rotor

[@ТоликКалюж-и5я]

Good afternoon. For pensioners, there are step-by-step instructions on how to set up a vertical take-off with two engines. Thank you very much.

[@maciejmotylinsky]

Hope soon will be possible set mixer manually and VTOL X Quad with 1 pusher motor will be possible to easy setup.

[@BBFPV]

Yes sure, but witch mixer is for tailsitter phase, can't find anything in RC1. THX

[@AerialWaviator]

Will INAV also support Belly Sitter VTOL? example: the FIMI Manta shown in the video could be easily converted to Belly Sitter just by removing the propeller on the rear motor (or adjusting C/G if motor removed). To convert to Tail Sitter would requiring modifications so could be armed and launched vertically.

[@FPVBites]

You mean a bicopter? Yes, INAV supports bicopters

[@AerialWaviator]

@@FPVBites A belly sitter has two motors with servos like bicopter, so hovers like one; but for takeoff position is sample as a fixed-wing. The initial takeoff sequence is to lift up to a tail down position. (propellers remain parallel to the horizon) A bicopter in contrast has landing support (gear/structure) that stabilizes so motors already in hover position.

[@trafton00]

2 servos that can control the flaps? Do that motors need tilt also for tail sitter?

[@prmpfbubub]

no need to tilt the motors. the simpliest form of a VTOL is a wing with two fixed mounted motors and two servos for elevons. four channels in total for the flight controller.

[@Sonic_Ox]

Does INAV 7.1 offer any benefits to the quadcopter pilots over INAV 7.0?

[@FPVBites]

some bugs fixed of course

[@Sonic_Ox]

Thank you. I'll flash it soon.