Installing 20" Light Bar On 2018-2020 F-150

[@Arthurmd22]

Can you give a detailed explanation of how you get through the firewall? Do you cut the rubber grommet? Do you push from inside the cabin out to the engine bay or vice versa?

[@alecmorgan4945]

What's the part number for the brackets

[@bobpetrel1558]

What was the part number for the mounting bracket?

[@richardyoung4400]

personally , i run and tap the lights to the foglights...awesome vid man

[@kosieS]

Question how do you connect your bar to your high beam so it comes on when you put your lights on for off road convenience?

[@jordanalexander1592]

I would assume you'll have to physically splice the wires together. Unlike using Forscan to enable Bambi mode

[@Thyslop07]

Good vid. I’m looking to do same thing. Gotta figure out how to lower my front plate.

[@blomeoutdoors2134]

I’ve seen people move their plate left or right, and it basically sits over one of the bumper covers

[@Thyslop07]

@@blomeoutdoors2134 yes I’ve seen lots do that. Don’t really like that look. Want to mount it under the bar. Still happy with the KC bar? I haven’t decided what one I want. I don’t want Amazon crap but the rigids are so damn expensive.

[@blomeoutdoors2134]

@@Thyslop07 I’m happy with it, no issues with it so far.

[@AngelRamirez-pu8po]

What lift is that looks nice

[@korywarrington8179]

Nice looking truck!! Where did you pick up those switches? Like you, I hate the switch my grille light bar came with.

[@alsaint7944]

Anyone have the part # for the brakets used the links he posted do not work..thanks

[@MurderedF150]

Any recommendations to make the metal not rust after cutting it?

[@fostermcmillan]

Great video, keep up the content!

[@sandhu1661]

Very nice.. What about the lift setup n tire size

[@blomeoutdoors2134]

In the video, I’m on a 6 inch rough country lift with 35x12.50 tires on stock wheels

[@txnaf1420]

Front end looks great. Truck looks great all around. I gotta say that I'm really impressed by the on/off swith. All these wire harnesses have the same ugly, generic-looking switch.

[@jakedaum]

What did you use to make the hole for the switch?

[@blomeoutdoors2134]

A step up bit

[@cheezer8888]

Bracket part number

[@GLP3]

You could have just cut the plastic down bars on the brackets and copped the piece back in

[@CHEECHMUN]

Sweet

[@cessealbeach]

NICE!

[@glb9024]

show yourself doing the work would be preferred