Installing A New 70cc Kit on my Puch Maxi

[@mikesbarn1858]

My dream moped. Love it.

[@mikesbarn1858]

Do you do any performance CDIs?

[@RestoCycles]

@@mikesbarn1858 I have before but honestly points are totally fine and I’ve never ran into ANY issues with them.

[@jdmaxi187]

Perhaps you have noticed since then, that you used a smaller old style head on a new style cylinder? The amount of fins on the side give it away.

[@RestoCycles]

Oh man, it’s been a minute since this bike. I remember nothing about it besides the fact that it looked amazing

[@dustinreaves8842]

is that just a replacement stock e50 head?

[@RestoCycles]

No, the head was a high compression head

[@mikesbarn1858]

Retired. Will work for pizza and donuts.

[@theoriginalmungaman]

Don’t over rev that engine, it has bushings instead of crank bearings. Not a good engine to build unless you install real crank bearings!

[@RestoCycles]

E50s have crank bearings and are the best engines to tune

[@nathanw5747]

@@RestoCycles old post ! i think he was referring to the bushing on the crank small end .. which is a known failure point ! you want the needle bearing crank both ends big and little .

[@Sinister_fartbox]

CocknBalls

[@RestoCycles]

To each their own

[@Sinister_fartbox]

@@RestoCycles bro change that air filter, 🤪

[@RestoCycles]

@@Sinister_fartbox I did really quickly, I did not like it at all

[@Sinister_fartbox]

@@RestoCycles oh thank goodness