Installing a SecureIt Gun Storage GunSafe Retrofit Kit into an Existing Safe

[@Blankford777]

Nice setup.

[@RobinP556]

I did pretty much the same thing. One thing that I did differently that could save you a little money is to put the taller panels higher and not buy the small panels. I did it this way, but it was purely dumb luck that I happened upon that.

[@ZackCarlson]

Yeah, but my OCD wouldn't allow that!

[@BeanieBandito]

I know is a 2 yr old video… do you have an update on the retrofit kit? Are you satisfied with it after a few years? Im debating doing mine i keep going back and forth on it Thanks.

[@keithchavez7190]

This is almost the exact same as what comes in the Winchester Evolution series safes.

[@ZackCarlson]

Good info thanks!

[@E.OrthodoxMHNIN]

Did you have to cut the anchors and screws they look pretty long compared to how thick the dry seems on the inside of my safe.

[@elite_7399]

So how are you going to place panels on the side walls if the butt plates take up the floor space?

[@tecumseh65]

So you have the attached screws going through the back of the safe?

[@ZackCarlson]

The safe is lined with drywall and I used screws into drywall anchors. Nothing sticks all the way through the metal of the safe.

[@Jordan-th8ps]

Theoretically, could I use just the rifle stock bases that go on the ground to have the rifle leaned against the side of my safe be more stable? Basically, if I wanted to be cheap could I go without the cradles for the barrel? Thanks

[@ZackCarlson]

I don't think so, but you can try before buying the rest.

[@Tom-em2wy]

Did you try with stock base only?

[@wervenom3513]

What kind/size of safe did you install it in?

[@ZackCarlson]

This is an iron man safe out of Idaho. The interior of most safes are drywall so the install should be similar.