Installing BACKWOODS BUMPERS on Polaris Matryx!

[@jasonmacdonald5141]

Looking sweet!!

[@drifter5682]

Get out to Revy young man the snow is deep already

[@Jacksquatch69]

On the rear bumper, there is one hole for drilling/riviting that is like directly behind like the running boards wheelie stomp/cross brace. How did you get those in? I left that one out on mine I couldn't get a drill or a rivit anywhere near to go in there.

[@nombr]

Solid video man. I stripped one my torx beside the tail light. Can I just cut that brace off or does the grab by use that mounting point? I couldn’t quite tell from your vid Also, could a guy put that front bumper on over polaris skid plate? Thanks in advance!

[@ChaseMasson]

Ya you should be good you only use rivits on the backwoods bumper so don’t need the bolt could drill it out

[@Jacksquatch69]

How did you get the bottom two bolts in under the sled without removing the pipe? I don't see how to get the nuts down in there..

[@Jacksquatch69]

Nevermind i'm an idiot. realized my hand can fit up in the front of the pipe and reach them.

[@semiproish5219]

Lets get 10 more pounds of muscle on ya like Caleb

[@ChaseMasson]

@@semiproish5219 it would take more than ten pounds man

[@Евген35]

Привет из России.

[@ChaseMasson]

Hello 👋