INSTALLING CARBON FIBER HOOD on my LEXUS 3IS! (2016 f-sport lexus is 200t)

[@Forced_induction1]

oh man looks amazing!!!!!

[@Jdmforall]

Thanks bro!

[@Forced_induction1]

@@Jdmforall ur welcome 💪

[@TurlosGarage]

Seibon makes a good product. Most carbon fiber parts are a pain to fit.

[@Jdmforall]

They really do! The hood fit surprisingly well. Time for the trunk now 😂

[@leoh391]

Does oem heat sheid fit?

[@zaysuvy2236]

hey man, great vid, hood looks awesome!! i kno its been a few years LOL but hoping you might be still active since i had a question about my hood install, how did u manage to adjust the hood either side to side or height wise after you first closed the hood? after the first look I'm assuming it wont sit perfect either and will need some tweaking. Ive installed a carbon trunk too and that adjustment process for that was somewhat awkward as we had to open and close it a dozen times as were losening and tightening the bolts that hold them ever so slightly until it sits right. even with this process, all the bolts ended up being tightened good minus one that is semi hand tight, tightening it further threw the entire alignment of the trunk off. was wondering if you had any better advice? Thanks again always my man.

[@Jdmforall]

Thanks! You can adjust the hood left or right with the hardware loose. I Just gently pulled the hood left or right to adjust and it will move very slightly. As for the height adjustment, there are rubber bumpers you can twist to lift the hood if it's vibrating or lower the hood if it's not shutting. Hope this helps!

[@leoh391]

Dose oem heat shield fit?

[@bretkovacik9258]

How did the heat sheild hold up

[@Jdmforall]

Great, no issues while I ran the hood.

[@alexisalvarado1924]

So oem heat shield doesn’t fit?