Installing New Single Pass Intercooler Om My Mercedes SL55 AMG M113K

Today we are installing a single pass intercooler on my sl55 amg.
Removing the stock 3 pass set up for a 1 pass set up. All the parts are from blood motor sports right here in the good old USA. Stayed with the 5/8 fittings just to see the difference and so I could get a bolt up set up. Will be going to 3/4 when I get my water tank.
We have a 10 f drop on average with the car. that makes me vey happy. The install was very easy with it being a strait up blot on.
If you would like this part contact June from Bloodmotor sport on facebook and he can make you one. Or hit me up on the GRAM (lol) and I ill help you get a hold of him.
My car set up is:
2003 sl55 amg
VTECH ECU AND TCU TUNE
VRP. 92MM TB WITH BILLET SNOUT
BLOOD MOTOR SPORT SINGLE PASS INTERCOOLER
CUSTOM INTAKE
CUSTOM SPLIT COOLING
EBAY HEATEXCHANGER

[@AprilRichards-kn1ch]

Good job on the commercials 😉. Thank you for saying what to disconnect before moving. I definitely would have broken a few

[@axelromerodiaz6018]

Seen you stepping on top of your engine bay to remove the SC was freaking epic!!! 😂

[@Nd_72]

LOL LOL yea it is the best way to do it lol

[@waltscrossfiresrt6]

Great video

[@OatesSteve]

Great info, thanks. Can’t wait for pulley time.

[@Nd_72]

soon ice box tune up headers then pulley

[@Luka5581]

Great content!

[@Nd_72]

thank you

[@newb529]

Blood the homie!

[@Nd_72]

yes

[@pfoxhound]

What's inside these side tanks? Where's the entrance for coolant and where's the exit, as if you have entrance and exit right at the beginning of those side tanks, than the liquid will not flow by the back of the rear portion of radiator.. if you could show the video of internal structure....

[@Nd_72]

next time I remove the supercharger I will but the camera one the holes. ooooo wait I could use a bore scope

[@pfoxhound]

@@Nd_72 yes! I've read the forum and those guys were saying that one pass didn't help, but actually decreased effectiveness of cooling charged air, but as you mentioned decreased recovery time, because of lower flow resistance. Other guy was describing how he drilled smaller holes inside, decreasing resistance, but results I don't remember. Other video source was describing two pumps inline were improving cooling and recovery, he used a stock and upgraded bosh pumps...

[@6.2Slomaro]

How much was it?

[@Nd_72]

I payed around 400 for June blood to make it fo me

[@bobgodd]

Lol!

[@percelsumpter95]

How were you able to get in contact with him? I sent hinm a message on facebook like two weeks ago

[@Nd_72]

I just use far book and have 0 problem but he is on a different time zone