Introduction to SolidWorks Flow Simulation

[@jacobframe8769]

Great video. Would you please post the files so I can review the set up and understand it better?

[@flymoto3870]

I m designing a unique centrifugal compressor,i know the inlet mass flow and want to calculate pressure at outlet,what are the boundary conditions need to be applied in this kind of problem,kindly help.all i have is a 3 d model and value of inlet mass flow.

[@lookiansing2582]

I have a water turbine design and I want to simulate fluid flow around it. Can I get the data of the velocity of the turbine's blades too?

[@C.J.M]

In a flow simulation of fluid flowing in a series of pipes, in a region of high turbulence in the pipe, how can I find the velocity of flow at a certain point in the high turbulent region over a period of time. Say for example, velocity at that point at 5 seconds, 10 sconds, 15 seconds, etc? Please I'd appreciate a response. Thank you!

[@sherifrayan]

how to make a flow simulation on a water turbine?

[@reidibrahim7176]

Hi Gents, I need your help, I am trying to get this SolidWorks Pipe Routing Training, is there any specific name for it other than Pipe Routing, any institute in India you know provide this training for Pipe Routing? so many institutes have full Solidworks which I am not interested in I need only Piping, Vessels and Flow Simulation, Please any advice, thanks.

[@mohammadsamiullah3924]

Hi sir , can I use the simulation of lubricants ? As I am doing a research on bearings and lubricant flow, viscosity etc.

[@allenrnewbauer]

Thanks for posting.

[@guilhermepena3547]

Hey you guys ! Some one of you can tell me If i can try a simple test to mining descharg with these ? Any one had try It ? Regards

[@eng.adamal-ali5656]

Please notify me if i can make flow particles like sand or grains mixing in mixer

[@jononipinchbeck2531]

Try COMSOL Multiphysics for that, less expensive than ANSYS and includes particulate simulation in composite flows. Depends on how well you understand the physics of the phenomena

[@STAiNLESS_CORE]

Kurt Curtain?

[@mariovelez578]

kurtin. I knew someone named John John lol

[@kmathisknylien7952]

Hello, I would like to have your help, this it does not bother you. I'm working on my project fim study now I need a tutorial, hows that, how you can learn to make a flow introduced with a temperature gradient in a pipe (2 pipe coaxial ,1 of 28 x50 and 20x50 thickness 2 mm), with, phase change materials, paraffin, amid 2, with inlet temperature 80 ° and 62.9 ° output, to consider a phase-change materials, on, solidworks. please it is urgent. and also the entry of water in blue, exit in red Paraffin and green, leaving the walls, in gray. Thank

[@ranjeet27766]

plz improve video quality i cant see the commands

[@paulogomes852]

man, please, change your mic, it is hard to understand and for someone who does not have a native english is worse

[@smellmyfingas]

Paulo Gomes

[@kraftythings]

Paulo Gomes

[@anasalami9112]

Paulo Gomes

[@nivdot7063]

Gomes Paulo