J35 Microsquirt Guide Pt. 4

[@frias2287]

Good job👍🔥💯

[@driven_nation]

Your making the wiring bit of my sway easy. Thank you!

[@karlkellner7009]

I love 3D printing for custom parts. Thingiverse has targa handles and AC vent guage pod.

[@Chuck236mg]

Will you be covering the programming set up to get it running?

[@soullesssol7285]

Yes. I’ll do a basic setup to get it started and suggest getting it to a dyno to get it tuned asap.

[@ricka12345]

Question I noticed you tapped the factory fuse panel which was hot at key on but that fuse is 20amps. The 3 amp fuse tap on it powers the main relay. How does a 3 amp fuse power a 40amp relay? I thought the main relay, ecu, fuel pump relay would need more than 3amps Thx

[@soullesssol7285]

The 3amp current only activates the coil on the new main relay. The power comes from the battery through the new main relay to the new fuse panel.(ps I would use a slightly bigger main relay like the 100amp, as the 40 is enough but get pretty hot. I have been running for a few years but it’s definitely not going to have a long life).

[@karlkellner7009]

Share this video series. Facebook Jseries & Jswap has 12,600 members. There must be a lot of people out there that need this information. Current wait time for a J series custom harness for a stock ECU is 6 months.

[@soullesssol7285]

I have shared it to a few sites. Hard to share it to all of them. I’ve also kinda held off on sharing every single one till I’m done with the whole series. I’m starting on the ecu one this week in my spare time. It’s probably going to be split into 2 videos as there’s a lot there to cover.

[@BLOJOHNSON3234]

Just out of curiosity, what axle setup did you use in your ef with the j swap?

[@soullesssol7285]

That’s a buddies car. His KZbin channel is TheHaggardHondaGuy. They are custom made from 2 different cars though. You have to ask him on his channel

[@BLOJOHNSON3234]

@@soullesssol7285 perfect, thank you! Love your videos btw, in depth and very very helpful! You give me hope!