thanks for the detailed videos...im for sure learning alot
@LegitRaceCraft2 жыл бұрын
Awesome! You're welcome
@Persocondes6 ай бұрын
@@LegitRaceCraftsame here, i'm learning a ton. i gotta run stock ecu as well to control the automatic trans for now, with ecumaster black. Question, so all i have to do for preventing check engine light with missing stock DBW throttle is to ground that DBW connector? thanks!
@LegitRaceCraft6 ай бұрын
@@Persocondes If you're running an EMU black then the check engine light should be controlled by it. The check engine light shouldn't be controlled by the OEM ecu anymore. It won't matter that the DBW triggers a check engine light. My oem ecu (automatic now even though my car is a factory manual) throws CELs for the auto transmission solenoids and some other stuff, but it doesn't matter since my CEL isn't connected to the ecu anymore, the CEL is controlled by my Haltech
@Persocondes6 ай бұрын
@@LegitRaceCraft thank you for the knowledge!
@TheApexofthevortex2 жыл бұрын
What exactly is that bracket you moved from the front side of the intake plenum? It has a plug one black and white wire coming out. Is it just a ground? I cut it put a ring terminal on the end and connected it to me intake manifold and when I tried to crank the car it would blow the AM2 fuse. When I disconnected it the car cranks again and doesn't blow the fuse.
@LegitRaceCraft2 жыл бұрын
The little gray box that is on the bracket is an electrical noise reducer. It just cleans up all of the electrical "noise" for the ground signal that the sensors share with the ECU.
@black240ct Жыл бұрын
Excited to go through this whole video and series. Question. I'm planning to run my elite 2000, ic7 dash and making a haltech flying lead harness for my 1jz swap. Not running a/c. What functions from the stock ECU/ body ecu would I need to focus on wiring or retaining. I suppose the only thing from the body would be the locking system if the immobilizer controls that. I'd love to get rid of the OEM ECU box and put the haltech under the dash
@LegitRaceCraft Жыл бұрын
Thanks! The locking system is controlled by the body computer, so removing the ECU shouldn't affect that, the immobilizer just inhibits fuel injectors from spraying, but I'm not sure if the doors will still unlock without the ecu. There is a transponder that communicates with the oem ECU, as far as I know it's wired entirely to the oem ECU and not the lock system directly. I still have my ECU connected for my a/c, and I'm still using the temp gauge on the dash even though my Haltech has its own temp sensor. I've tucked my oem ECU behind the radio (recent video), but I can do this since I have a slim face radio, it leaves a lot of room behind the ECU.
@black240ct Жыл бұрын
@@LegitRaceCraft right on i appreciate the info. Will have to start unplugging some things and see what stops working
@MontyT321 Жыл бұрын
How did you terminate the Bosch knock sensors? Any diagrams of the wiring layout?
@LegitRaceCraft Жыл бұрын
Polarity shouldn't matter. Connect one wire to signal ground and the other to the haltech.
@Morm1175 Жыл бұрын
Do you connect the speedometer and RPM to the haltech ecu or you still use eom ecu for that?
@LegitRaceCraft Жыл бұрын
Speed signal is coming from the oem lexus ecu, but the RPM is coming from the haltech