Ford Maverick & Bronco Sport Engine Cover Install

Kevin installs the JCR Engine Cover for the 1.5L & 2.0L in the Maverick and Bronco Sport.
Learn more:
www.jcroffroad...

[@ffield12]

March 30th 2024 .... Got my cover for my 2024 Bronco Sport 1.5 LT .... cover came in a speedy manner and had only a small issue with getting a wrench into and around the #2 ball since the head and the ball is larger than the 5/16" nut part and it crowded with other engine parts ... BUT I was able to hand tight and get a wrench in and snug it up. The other ball applications are basically wide open. The quality of the cover is great and couldn't be better. THANKS

[@danielbrazeau1680]

Very nice cover

[@joeb1096]

The early '21 Bronco Sport had the plastic and foam that covered the engine a lot more. Ford deleted the cover most likely for cost savings. This cover has venting outlets and is above the engine all around unlike the OEM cover. This cover looks great and helps keep the top of the engine cleaner,

[@RobertGarrison938]

I just put one on my 1.5L Bronco Sport. Easy install and looks great!

[@JADAR671]

I have a 24 Maverick with the 2.0L "B" engine as you guys are calling it with the canister and hard line and could not get the front drivers side to seat normally if I pushed down on it the passenger side rear would pop off. I switched brackets 2 & 3 and it fit like a glove and is perfectly flat & square. I'm thinking the upper driver side where you add the ball stud is slightly higher on this engine the reason it would not seat for me. It LOOKS GREAT cleans up the whole engine bay

[@JADAR671]

Can confirm a fellow Maverick owner found the same issue ,swapped brackets 2 and 3 for better fit

[@chetthibodaux5804]

Makes your engine run hotter holding the heat in the engine compartment

[@JADAR671]

there are more vents in that cover than your underoos 🙃

[@jcaputo3156]

On my 2024 Maverick Lariat the two rear brackets match up to the inserted ball nuts. There are no round ball nuts on the two front connections. The two front location are FLAT and offer no hook up to the brackets. The front brackets with the grommets just rest onto the flat area where there is flat plastic screw tops that have a screw driver slot but are not removable. It appears that the cover is held in place but why not is there a ball top not available for the front grommets to hook up like the rear grommets do.

[@JcrOffroad]

Shoot our tech support an email and we can help! [e-mail]

[@bobgootee2920]

Is there a cover for Maverick hybrid engine

[@JcrOffroad]

We do not have a version for the hybrid at this time.

[@chetthibodaux5804]

Engine covers on cars, suvs and trucks hold heat, can pose a serious fire hazard. It’s useless