JD 2020 HYD FLUID AND FILTER CHANGE PART 1

[@qrash8547]

Years later and still helpful, thanks for sharing.

[@WorldsOkayestFarmer]

Great thanks for sharing

[@pushrod3022]

Thanks for posting this. Made my life much easier working on my 1530. I almost did the same thing you did with the bolt on the bottom of the bowl. You saved me there!

[@WorldsOkayestFarmer]

Great glad it helped you!

[@deernutOO]

You are NOT an idiot, or stupid. You gave your viewers a real presentation and video of the prep for removing filter and screen.. often what we run into when doing something like this for the first time.. looks like water in the hyd. oil.

[@mikep32]

Thanks for the valuable info. I have a Model 2020 and I don't think it has ever been serviced. The hydraulic fluid is full but the brakes don't work and the hydraulics are 2 inches per minute slow! The engine (gas) is strong so it's my project. I will clean the two filters and replace the third and see how it performs with new fluid. Thanks again.

[@WorldsOkayestFarmer]

No problem thanks for watching! I bet your screen is plugged like mine. Esp because your brakes are not working and a lot of the shavings from the brakes will clog that screen.

[@scottw.2450]

Thanks man, we have a 2640 and is has pretty much identical hydraulics. Not a simple job. Like you said the manual doesn't really go into detail about the whole process. You probably saved me a lot of mistakes when I changed the fluid in ours.

[@JnIII16]

Outstanding video! Suggestion that I learned from a local John Deere mechanic (40+ years), remove the screen plug first. This may ensure most of the debris/shavings that have accumulated on the screen are removed with the screen and don't fall off screen when the lower drain plug is removed. If the lower plug is removed first, the flow of hydraulic fluid/gravity may loosen some of the debris off the screen and this debris could remain in the tractor after all plugs/screens/filter element are replaced. Also, I use a long tool recovery magnet in the screen area and slowly get any additional metal shavings. Hope this helps.

[@WorldsOkayestFarmer]

Good tips that screen was a mess and slowing my hydraulics big time

[@qrash8547]

Thanks

[@dwightackerman7921]

Sure looks like this service was really needed hope the hyd pumps okay.

[@WorldsOkayestFarmer]

Yeah big time. The hydraulics were starting to struggle. Thanks

[@mckinzey62]

I have a JD 2240. This helped a lot. Thanks.

[@WorldsOkayestFarmer]

Great to here!

[@nelsonvieira4189]

Co

[@jerredwayne8401]

This looks very similar to my 2150. I hope it is because I'll be tackling this project soon

[@petshoptalk576]

You said “I’m an idiot” lol that is something I would say

[@blakesummerlin7619]

I have a 830 Jd pretty much exactly same tractor busted my thumb breaking the plug loose on screen also. The brass is from the breaks coming apart on the screen. Filter will be full or it also

[@WorldsOkayestFarmer]

Thanks for sharing!!! Glad to know about the brakes! I really jacked my hand up for a few days.

[@ronnieberg2277]

Great video very good information was just what i needed to know

[@WorldsOkayestFarmer]

Good I appreciate it!

[@jthomp997]

Hopefully this helps with my 2030. Haven't had it for too long and it came with the property. Really solid tractor but when you run the pto for long periods of time the hydraulics will randomly stop working until you turn the pto off for a second. I believe its the filter and screen causing the problem but I haven't had time to dive into it. Hopefully this winter though that will change

[@WorldsOkayestFarmer]

Jack Thompson very good chance once you clean them it will run good as new!

[@bernardhawk6929]

Good video. Be sure to wear your safety glasses.

[@Dmenbiker]

I have a JD 401 and this helps a bunch...

[@WorldsOkayestFarmer]

Great!

[@Dmenbiker]

@@WorldsOkayestFarmer You have the BEST description and details of anyone I've watched so far...

[@WorldsOkayestFarmer]

@@Dmenbiker thank you I appreciate the feedback

[@sweetfarmsllc8886]

I would flush again, you have water in the system. Usually takes 2-3 times of new fluid to get it clean.. Any black material on the screen would be brakes, metal it not good. Something is failing, only a matter of time.

[@WorldsOkayestFarmer]

Thanks I will flush again. Hope it holds up! Thanks for watching

[@tynelson7367]

O Ring does come with AR75603 filter, not sure why you didn’t have a o ring.

[@kennethmarlow2731]

I totally agree, you need to flush it till it comes clean

[@dukeman7595]

That's going to leave a Mark. That was funny, sorry but the way you said it cracked me up. The way that screen and fluid looks it appears the hydraulic fluid has never been changed. Well at least you learned how the filter comes off for next time. Great job.

[@WorldsOkayestFarmer]

Joseph M no doubt thanks for watching

[@citizen1675]

Thank you! Life saver

[@WorldsOkayestFarmer]

Welcome thanks for watching

[@dbirchwood3732]

I’ve learnt so much on your videos. I own a 1830 John Deere and it’s exactly like the 2020. I have a question: have you done a video on putting a light / wiring hook up video? I look forward to your response.

[@WorldsOkayestFarmer]

I have videos adding lights but i dont know if i show the wiring. Not much to it . Use the existing switch or add one. Two wires to the switch. Two wires to the light the switch is usually labeled on the back. From the battery or you can tie into an existing switch

[@tomroot6013]

I am considering a JD 300 Backhoe. It is basically the same as a JD 2020. My Screen is on the other side of the housing, and I can not seem to get it out, at all! My fluid drain was a few quarts of clear water, then it transitioned into that Light Brown stuff you had! ! Since the Gear Shift Rubber Boots are toast, and it has been sitting in the weather, it had a LOT of water! I was told that has to be covered, and the Rubber Boots intact, by my local JD Dealership? How water can get into a closed system, is beyond me? It gives me hope that I can get this thing going! The last it was ran was over a year ago. The 86 Year old owner passed away, and the Sons had No Idea of what maintenance was! I sure hope I can rescue it! Now to figure out how to fix the Inoperable Brakes....anyone seen a Video on how to do that, perhaps? I think I have to break the Case and replace Hard Parts Galore! Thanks for posting this up!

[@WorldsOkayestFarmer]

I have a maintenance manual for the 2020 if they are the same I can email the task you need out of it.

[@tomroot6013]

[e-mail] Thanks! Much appreciated! Have a good one!

[@tomroot6013]

Also, I have the Operators and Parts Manual .pdf...if you want or need that?

[@WorldsOkayestFarmer]

what part do you need its a book I don't want to have to scan the entire thing. Brakes?

[@tomroot6013]

Ohh, sorry, I thought you already had it in .PDF form! No please do not scan the whole thing...LOL! And no hurry either, I am taking my time, and will eventually get 'Round Tuit! ;)

[@samharmon92]

Good job.

[@nmjazz09]

Really appreciate the video!

[@WorldsOkayestFarmer]

Thank you

[@nmjazz09]

@@WorldsOkayestFarmer Just bought a 1020 and your video helps me a lot. I was raised on Red Tractors, so there's much to learn about the Green Machines. Thanks again!

[@WorldsOkayestFarmer]

@@nmjazz09 good luck with it I hope is serves you well

[@glenyost1]

hopefully the 2130 is the same..very helpful

[@WorldsOkayestFarmer]

Thanks around that time a lot are

[@reckless3008]

Struggling right now with that o ring

[@amathonn]

Can you tell me how the gasket/o-ring is supposed to be installed with the hydraulic filter? I didn't see one when I took mine apart but several of the filters I've seen advertised online come with one.

[@user-ry6xo8nb5w]

شكراً على المعلومه

[@johnnyholland8765]

The entire transmission and engine cavities are painted with a type of primer that is supposed to help seal the castings and promote fluids (engine oil and hydraulic fluid) flowing back into the sump for filtering and return to the system. I don't think it has been changed in a very long time. Had to do the same thing to mine. Just flush everything and replenish with good oil.

[@WorldsOkayestFarmer]

Johnny Holland thanks for the info we are in good shape now and I will be keeping up with it!

[@Cake41579]

It’s called a hydraulic port or

[@bryancovert9821]

When you say that you are a idiot on tape , it's usually down hill from there . You're in the military or were in the service. You know the deal , " prior proper planning prevents piss-poor performance " , and no busted fingers. Hey when you bought the front wheel assist John Deere in Penn Yan N.Y. from the Mennonite on Preemption RD. When you pulled out of the driveway, that little brown house at the end of the drive is one of my best friends house , he's an old biker like me , we all call him Beagle, I won't go into that . But if you would have turned left and went into town , went south to Bath N.Y. then west on 87 , nice new road straight over to Erie Pa. I see you ride a hog , my brother's 67 yrs old he has two shovel heads and building a evo . I have a 04 Suzuki 83 c.i. v-twim with 200,000 mi. on it , I need to do a couple of things to it before it goes back on the road . But hey , read that shop manual youngblood, you might need those digits later !!!!!

[@WorldsOkayestFarmer]

Bryan Covert Hey thanks! When I bought that tractor I came into Penn Yan the way you described but it was the first time towing that tractor and I didn’t want to pull that big long hill coming into town so we went north to 90! That’s cool you guys all ride! Thanks for watching!

[@user-ry6xo8nb5w]

كم عدد الترات عندما ابدالدهن

[@Cake41579]

You better hope it drains all of that mess out. It appeared to have water in the oil. Thays

[@amathonn]

I have an old John Deere industrial that's similar. What was your original problem that made you decide to work on yours?

[@WorldsOkayestFarmer]

Andrew D the hyd wouldn’t lift my corn planter anymore or the loader.

[@incubatork]

Someone may have put non JD compatible oil in there and it make the oil emulsify

[@axelec]

Those screen plugs are horrible tight. Some tractors have two oil drain plugs before you drop the oil filter bracket. You certainly have seen the do and donuts in this video

[@user-ry6xo8nb5w]

كم عدد الترات عندما ابدالدهن