Jeep JL JK Wrangler JT Gladiator UTV 8 Gang Auxiliary Switches Installation & Review

[@MeetTheSLAYER]

FYI, the relays you used is redundant. As the fuse panel for the switch has relays for each input.

[@BasoholMedia]

nice, i went with the 6 switch, and used a grab bar phone mount to hold it.

[@ottoninos5073]

a question those two small cables, one is white and the other red, where did they connect it?

[@frfghtr1027]

Where did you run the power wire too for the switch panel? Did you run it to the fuse box with a fuse tap or direct to a source?

[@markvirgona1752]

I just installed this unit in my JT but tried using a fuse tap on cig lighter to power panel in cabin it works but as soon as I close hood it cuts the power to panel

[@MohawkDaveOffRoad]

Check your wiring with a volt meter.

[@KTMcaptain]

I used an add a circuit to the heated seat fuse.

[@dab0yhdizzle]

Nice video quick question I have many lights on my jeep as bar light pods rock lights and whips I Have each Is separate switch each has wiring harness kit I'm wondering that's kill the battery or do I need swtich panel? Thank u

[@officialWWM]

Looks identical to the Auxbeam one.

[@JimCantu]

I just got the Auxbeam 8 Gang Switch Panel and it does look to be identical to include the mounting brackets and even the box that it comes in. Hope the Auxbeam works because I could’ve saved some money getting this one!

[@MeetTheSLAYER]

That is because auxbeam outsourced it and it was rebranded multiple times. Some have an issue with clearance for the button on the breaker.

[@overland_explorations]

I like where you mounted the switch panel. What screws did you use to mount it there, and is it a strong hold? If you used bolt and nut, how did you gain access to secure them?

[@MohawkDaveOffRoad]

Thanks! I used a 3M strip and self tapping plastic screws. I wiped the spot with isopropyl alcohol to make sure the double sided 3M strip sticks well and then I drilled small pilot holes for the screws. It does not move.

[@overland_explorations]

Thanks!!

[@markg3305]

Using outside relays for this is actually a negative. The circuit board itself has solid state relays so you can straight wire all accessories straight to the panel.

[@jasonstorie8740]

Are you able to run a winch on this system

[@MohawkDaveOffRoad]

Yes. You can

[@Richardwhite-h2c]

So the back lights stay on all the time?

[@losdeapie9499]

Same question here

[@JEEPIMPACT]

Is this still working well?

[@MohawkDaveOffRoad]

Still works perfect on the Can-am and the Jeep.

[@JEEPIMPACT]

@@MohawkDaveOffRoad I ended up going with Voswitch for the direct mount. Now I'm just trying to come up with enough stuff to use all the switches. Great video thanks!