Jeep Overheating Issue Solved

Jeep started to over heat .. found simple solution to the problem

[@billyoverholtz7036]

Just wanted to say thank you! My 2009 Wrangler started doing the same thing yours was, tried your "fix" and it worked like a charm...

[@mattrichardson5343]

This video saved me a bit of time and probably money too. Corrected overheating on my 2007 Jeep Wrangler Unlimited. Thanks for posting.

[@juancarrasco6598]

You were spot on my friend. I positioned my Jeep in my drive way, removed the cap and air came out. Took about a quarter more of fluid. I turned on the vehicle, let the fluid bubble over and placed the cap on. IT FIXED THE ISSUE!!! Thank you for the vid.

[@ATSUMA1314]

I followed the steps and my car has been fixed with this simple trick. Thank you, it saved me a lot of money. Recommended not sure if it works for all cars but it sure works for jeeps

[@Nelsoh_]

I just changed my radiator hoses to the mishimoto hoses and I’ve never had an overheat problem. No leaks. But as soon as I did that and let it run for a little bit aka idle, I saw it went up a little past the middle. I thought it might be air pockets and I need to get those out and I loss a bit of coolant haha. Thanks for the video though! Helped a lot actually!! I have a Sahara too haha so anyone with a Sahara I like their jeep the best haha :) great video with details!

[@juancarrasco6598]

Thanks partner. I’ve been experiencing the same in my 13. We’re going to try this later today. Temps have been over 100 lately. I was thinking that I needed an aftermarket hood to allow the engine from heat soaking due to high temps. That will happen later. This solution is more cost effective. 🙏🏻 Stay safe.

[@WorldGrace]

If your host from the radiator is hot up top but cool hose at the bottom be sure to get the computer codes if you do get a check engine light, pressure test next to also make sure… stay safe you and Jeep!

[@ElonMuskForPresident]

This makes sense! My Jeep only gets warm on incline In the mountains! Thanks for sharing!

[@EarthSurferUSA]

The 2013 JK, (I own one), has heat issues too, even with new cats. I just found a huge, (but very inexpensive issue to fix), problem with the thermostat, and it is an easy fix. 1st, It uses a 203 def. F. thermostat. It fits inside of the plastic housing (for the radiator hose), and I just tested the assembly, in water, bringing it to a boil, (220 deg. F.) in a pot on my kitchen stove. I get it to 200 deg, watching it, and it barely moves, (does not open). The problem is a gap of about .25" between the end of the plunger rod, and plastic of the housing is inserted to. The rod has to move .25" before it starts opening up the valve, and because of the way the rubber seat is designed, it still has to move .100" more to even open up. It is the pressure in the engine e block that opens it up, and it does not flow enough water to keep the engine cool. When it gets hot enough to possibly cause some engine damage, the engine management system starts to shut the engine down so it can't produce more heat and boil over. Now the mechanics will replace all the sensors that get tripped,---and that is because the poorly engineered/manufactured thermostat does not have a sensor to trip. All you have to do to fix it is put a .250" long(approx), piece of metal rod between the end of the plunger rod of the thermostat and the plastic that it bottoms out on in the housing, where the end of the rod slips into,--fill the open gap, and the valve will open all the way. I would make it long enough so you can feel it when putting the thermostat in the housing, and have to compress it just a bit to fully seat. Then put on the spring and strap,---and the engine will at least cool as it was suppose to be designed. If you are having heat problems with your 2013 or similar Jeep with the V-6 Pentastar engine, all you have to do is buy a thermostat at a auto store, (I have Napa Balkamp, about $14.00), and put it in a pot of water, boil it, and see what it does. It will move when it hits about 220, but it will not open. The plunger runs out of travel with that .250" gap in there. Your welcome: Doug in Michigan :)

[@SuperRobkar]

I noticed the same thing when I changed mine a few months back. I think I filled in that plastic space where the rod goes into.

[@jg4585]

Make a video

[@autonomous_collective]

Thank you for sharing.... solved my issue.

[@viper11romeo88]

I did this and it friggin worked! Thanks!

[@ML-my8qq]

Did you put the additional antifreeze into the reservoir or directly into the rad?

[@zacharybrown6111]

Thanks for the info. I am gonna give this a try.

[@harvortiz4756]

One thing that will help, when you drain the old radiator fluid, replace the entire plastic inlet with thermostat. Then when replacing half/half fluid. Power on the Jeep and turn on the heater inside full blast, while the rad-cap is off. Continue adding water until it’s full. Wait until it’s warm and you see the fluid moving. Power it off, wait until it cools. Elevating the front will help. Last top it off with water and close the cap. Make sure the cap is good and not old, the reservoir tank will fill automatically. Test drive it around, if it overheats again? You still have air somewhere in the cooling system. Thanks

[@kruelzombieful]

Get the AEV fan conversion kit. That would allow you to install the 2012 and up jk fan assembly. Fan flows twice as much as the 3.8 fan. I vacuum fill mine always. Worth the 100 dollars for the tool.

[@DjGabrielEscobar973]

Man im dealing with the same thing. I would appreciate a write up if possible on the steps to ensure nothing is missed.

[@sayedasad3706]

The same issue I have been facing. I did something similar and as I switched the engine on within seconds the coolant liquid came to the surface is when I closed the cap. But the heating issue still persist.

[@TheRealRemedy1]

Just did my intake manifold gasket because of the infamous leak and now have that slight overheat when I step on it ... definitely gona try this out👍

[@VoiceBoxofDaBlockTV]

Did it work I just did the same

[@lmacatol]

Thank you! A worked for me

[@gsimard4510]

Thx man ton of air in mine too regular temp now!

[@spencerwarren9219]

My 2003 rubicon tj only over heated when ac was on which caused coils to miss Fire when hot. It would get to 215 from regualr temp of 210 only when ac was on. I replaced the fan clutch for 65 bucks and now with ac on high at red light on gets to 211 and then when clutch spring kicks in drops back down to 209 to 210.

[@jrprieto1]

Thanks for the video, I got a 14, hopefully this fix will work on mine too.

[@kevintorres5663]

Currently dealing with my 14 as well... Replaced the water pump and thermostat, that solved the issue for about a year and now it's overheating again... No leaks, typical air in the system symptoms, but the "spillproof funnel" method did not work for me. Good luck with yours!

[@Joshua.ceronn]

@@kevintorres5663 were you able to figure it out?

[@kevintorres5663]

@@Joshua.ceronn had to replace the radiator! No more issues after that, took me about 4 hours

[@Joshua.ceronn]

@@kevintorres5663 Man that’s good to hear! Mine is barely starting to overheat. I’ve noticed that after about 20 minutes the fan on the radiator starts blasting air. It actually manages to keep the car on “normal” temperature (on the right side of the middle line but still touching it). So I am guessing I have a leak somewhere or maybe hopefully just a bad sensor. I do not hear any noise from the water pump and I have a new thermostat. No coolant on my oil either. So hoping for a quick fix.

[@kevintorres5663]

​@@Joshua.ceronn Oh man, mine started doing that exact thing, kinda hovering over half while sitting in traffic, then lowering once I started to drive. Happened around 85K miles, did the thermostat first, then the water pump (I actually did have the hissing with the heater on) then I finally replaced the radiator around 100K miles because I was tired of living with paranoia LOL. Figure my Radiator had some sort of blockage or buildup. Also I guess our radiators are good for about 80K miles. Not all Jeeps are the same, but I hope you get it resolved!

[@werfamily9190]

I have a2017 wrangler and experienced the same. The water pump, thermostat AND heater sensor have been changed and I have to constant “burp” the coolant system. I’m wondering, since no one has mentioned that if the authorized ZEREX G05 coolant is not being used. Just something to take into consideration. Jeep on y’all

[@davedeece9380]

Did you fill it from the radiator cap or over flow resivour?

[@omarsoto407]

Did this fix the heating permanently?

[@nerdCopter]

Thank you!

[@elitheprofit7084]

Was your radiator fan running when it was overheating?

[@timbuk2.019]

Thanks good info

[@albrown6253]

I just had a coolant flush and my jeep is starting to do this gonna try what you said will update if it works.

[@markrequena8993]

Al, Did it work? My jeep was not overheating until I did a coolant flush …. Maybe it has too much air as this video explains

[@charles1k700]

does this work with all jeeps? because i have 2012 jeep patriot sport 2.4L and I am having the same issue?

[@jinoh7418]

So it was because of too much air? I will try this. Mine overheat during steep incline.

[@m9katchm9]

What was your issue?

[@jinoh7418]

@@m9katchm9 my radiator cap was leaking. Cheap fix.

[@sunnydaze5674]

It’s too bad Jeeps always have problems. They’re such fun cars.

[@WILL-lt1du]

And they are sluggish

[@Silversphincter]

Get a jeep made by a.m.c

[@zoobrizz]

Grow up. Better than most and I can actually work on them

[@offplanetevent]

Mine has 220K on it and no issues. Oh wait.....I had to replace a tire pressure sensor on it, but I think the guy who put new tires on it broke it.

[@BEINGOOD77]

@@WILL-lt1du Well, to be fair, sometimes the owners are dense. Once a jeep owner Always a jeep owner.

[@Destinoffshorefishing]

Looks to me you have a leak from the looks of the bottom of that intake hose

[@aarondmtz2178]

how many miles do you have on it?

[@grantonrigney9208]

Mine doesn't overheat but it started steaming and I think it was caused by a leak of coolant on the ground that started to evaporate because it was cold outside. Could it be a radiator fluid leak?

[@GPTAdventureChannel]

could be coolant leaking on the exhaust?

[@roshUlit]

Could this also happen to newer model Jk? 2018 model Jk to be exact

[@MegaPossesed]

Yep

[@Cool_2468]

This is eventually gonna end up head gasket issues or warped those aluminum heads.

[@Steve-zq8ge]

What happened to mine. Months after doing this the dealership says I have warped cylinder heads and failed and block test prior to that.

[@Steve-zq8ge]

I’ve had this done and my thermostat replaced 4X and it constantly tells me code P0057 and had the down 02 sensor replaced 3X as well. Still no fix or find for overheating. Poorly designed engine in the 2015 JK Willy. Had it for a year and been a nightmare.

[@HovaShowstopperz]

Thank You soo much, this literally saved me hundreds if dollars. Worked like a charm, Amazing.

[@samandkay26]

When you added fluid did you add on reservoir or on the left side.. thanks!!

[@e.b.6766]

My question is how does the air get in the system. It’s a closed system… if you don’t open it air should not enter.

[@alexm9548]

My car got so hot that my water temp gauge doesn’t work anymore it goes up kinda but doesn’t go all the way up

[@hungryjulio1269]

🎶96 degrees in the shade🎶

[@justanotheraviator2357]

Just pull the fan control fuse out and it will always run full fan.

[@fearthetriangle]

Where is the fuse located?

[@johncaldwell1143]

bDEEP BDEEP iM A TECHI=ENEIECIAN YALLL FUCKING DUH..KNOW SHIT NOTHING ELSE

[@wulfclaw4921]

Damn ! I THINK IT'S TOO LATE. I PULLED OFF hiway. Oil gage read hot, clunk coming from bottom end.😭

[@buttheady429]

Check it out....the one and most important thing is to zźFLUSH THE HEATER CORE OFTEN...I myself eent through an extended battle on 2015 wrangler overheating, no hot air on heat than have it all work randomly...i flushed the radiator, because of the overheating had cyl 6 misfire which takes out the o2 sensor downstream...than pit in the 5th thermostat, after 1 month...i just changed the wayer pump prior...flushed the HEATER CORE, NOT EVEN VERY LONG, put it back together ,than i removed the thermo housing,and flushed the block, exclusively..put it,all back, fired it up... Aaaaand...ran BET🎉TER than day it was bought. IT USED TO HAVE A"FLAT SPOT"IN THE THROTTLE,THATS FROM DAY ONE, AND IT IS GONE AS WELL...HOPE THIS HELPS..HEATER CORE...VERY VERY IMPORTANT..

[@Steve-zq8ge]

I’m having the exact same problems man and it’s killing me. Hope this dies the final fix!

[@PR-pm6ql]

Do you put the coolant into the radiator or into the reservoir?

[@irafair3015]

Put it in the reservoir.

[@robertogeranio-rampone2775]

Ok bad diaigned water pump diafragm it fail an the pup don work then oberhatin because the water dond suction the hesds properly the air i time we its hot blows the coolant an loss water solution change new water pump

[@WorldGrace]

Freaking Jeeps still overheating from 2012 on up? I just had to redo full head assembly gaskets and everything twice on. 2012 Jeep Rubi #4 Cylinder misfire in less than 10 years it’s at the machine shop now… Pentastar sucks?

[@panchovillaz8004]

You killing the engine son you have big problems

[@powershop1903]

it was the thermostat

[@gregmuniz7571]

You bled your radiator. Not rocket science