John Deere 300 Series Tractor: H1 to H2 Conversion

[@beaglebrothers1]

And just a tip.......when I am working on this thing, I put it up on cinder blocks. It raised it up another 7-8 inches, and was much easier to work on. The tractor won't move forward or back when not running.

[@beaglebrothers1]

When I mounted the H2 hydraulic control box underneath, I used the original hole on the top, but drilled a new one at the bottom. This put the box at a 45 degree angle underneath, and lined up PERFECTLY with the hydraulic lines from the transmission. I didn't even have to tweak anything. They just connected up straight away.

[@beaglebrothers1]

As far as the snap rings around the hydraulic connections up front.......I had to use the 90 degree snap ring pliers. It was a little bit of a pain, but I got them eventually.

[@NCDude-hg3no]

Thanks, I enjoyed watching it. I have a 318 that friends think should be replaced as I am always working on it but they just do not understand.

[@Deadmoneygarage]

😂 I tell everyone legends never die. But do require maintenance. Thanks for watching

[@ronniehenry8983]

Where did you get another tractor for the parts you needed I need a grill for a 330 by the way great job

[@Deadmoneygarage]

I just continuantly check Amazon and eBay for parts. Thanks for watching.

[@fishnriver]

music music music???? what gives???