Honeywell RTH6580WF | SETUP Menu Options EXPLAINED | Thermostat Installer ISU Settings

[@magnagaurd]

Thank you for this video

[@abenwinUT]

Where can I get that manual you were using. Enjoyed your video. Great Job!!!!!!!!!!!!!!!!!!!!!!!!!

[@john-sw1nu]

For the honeywell rth6580wf is it possible to change the hysteresis or swing?

[@gabrielvazquez3727]

Thanks for the information. Do you know how to adjust the temperature differential (swing) on this thermostat? Thanks!

[@robertmartinez9480]

I have a gas furnace, t-stat was factory set on option 6. (Cool) blinking with no cooling. Switched to 5, thanks to your video. Operating properly.🎉

[@angelamcdonald7071]

I wish I had found this video when I started troubleshooting my furnace. My thermostat had worked fine for a year but then when I tried running the furnace for the first time this year it wouldn't fire up. Turns out the thermostat got set to a heat pump system somehow. Not sure how it happened but it's now running the furnace properly again. Thx

[@canmind]

Thank you!!

[@takyra23]

I am having trouble with this thermostat. After I registered the thermostat, the screen turned off and will not turn back on. I have tried all troubleshooting tips listed in the troubleshooting guide for this issue. It turned on for a few seconds after turning the breaker off and then back on.

[@Mark-g2b9x]

I am having trouble registering this thermostat. Keeps saying unsuccessful. I am not sure how to wire my central air unit to the control board. I had to run new wires because the HVAC company that installed my Rheem, didn't install both stages of the furnace. If I connect the wires that were on before, they may be wrong. I have a one stage central air unit.

[@LuisSantos-i2s]

How to change it from Celsius to F thank you very much

[@madgemccoy4695]

How can I change the times the system does change over an hour?

[@omardabbous9571]

Factory reset