Junkyard Yamaha PW80 Build Ep 6

[@owl1873]

Brother I love your enthusiasm and comitmen to your frankenbike. The fact that you were able to save those forks alone confirms you are a Master Macgyver.

[@alrezgarage9046]

Finally I been following this series for a while nice to see it run

[@wickedoffroadmachines]

I had one those years ago wish i would have kept it. Nice to see somebody build a two stroke pit bike

[@eimendodo478]

hello can you tell me where the blue wire of the ignition plugs in thank you very much

[@Yatta760]

We’re can I get a gas tank like that

[@twistyfishy]

Can I have the link for the uni air filter?

[@MechannibalGarage65]

www.rockymountainatvmc.com/parts/uni-2-stage-straight-clamp-on-pod-filter-p?s=1040989

[@prodrift101]

Sounds like crank bearings. I’m in the process of doing mine.

[@troybullock3027]

It’s probably the main bearings

[@deanali1796]

Alright mate, abit of advice, DO NOT exchange out the air box, keep to the original, you’ll have all sorts of issues pop up, keep the foam inside aswell, honestly it’s a bad idea, good luck 😉

[@leescoey]

PS YOUR TOP HEAD IS ON UPSIDE DOWN

[@wickedoffroadmachines]

That noise is probably the crank bearings freeing up. The noise should go away

[@nefty06wokawoka66]

Nicee

[@austintaylor2251]

2nd

[@diehard2033]

All the work 2 0ut a chineise seat on a yamaha pw 80 in england pw are a national tresure along with the 50 lt 50 and lt 80 u cant put a crappy seah cover on after u did a rebuild makes no sence is there only me who has a problem replacing seat cover for garbage one🤣

[@MechannibalGarage65]

I agree, working on a budget you gotta make compromises and that was one of them :/