[Kangaroo2] Basic #06 : Add Anchor Points 2

⭕️ 채널에 가입하여 혜택을 누려보세요.
/ @rhinograsshopper
-
[Kangaroo2] Basic #06 : Add Anchor Points 2
-
Don't miss out subscribe. :)
영상이 마음에 드시면 구독과 좋아요를 눌러주세요!~ ^^
라이노+그래스호퍼 Naver Cafe : cafe.naver.com...

[@tshoooooo]

solver doesn't allow for more than one command to connect. It's either edge lengths or show or anchor, but not all three like your video. What am i doing wrong?

[@RhinoGrasshopper]

Hold down the Shift key while connecting.

[@ArquitectureTutorialsbDarija]

thank u so much @@RhinoGrasshopper

[@梁之䮋]

u really helped a lot@@RhinoGrasshopper

[@andreafabietti756]

@@ArquitectureTutorialsbDarija the correct way is to plug the commands in a merge and then the merge box u connect it to solver. In this way you give an arbitrary order. Instead if u connect them all together u dont actually give it a specific order

[@lberro87]

What do you do before the "closet point" parameter when you enter the point, what does it change with a purple box?

[@VerdiStudio22]

May seem like basic but this solved so many issues for me, Thank you!

[@ThirdDegreeGurn]

Hey man! Great video, helps alot! How would I round the anchor points more? Like there is a pole under the fabric sticking up? I am trying to make a tent pavilion with it

[@RhinoGrasshopper]

You can use a circle component for the anchor points, create a circle, and then extrude it in the negative Z direction.

[@ThirdDegreeGurn]

@@RhinoGrasshopper I apologize, but could you elaborate for me? It still seems to pull the tent towards a point in the middle of the circle that I made. That's probably because I put it into a "Closest Points". But if I connect the circle directly into an Anchor Point, nothing happens. Disclaimer, I'm somewhat of a novice when it comes to GH.

[@RhinoGrasshopper]

@@ThirdDegreeGurn Could you send me your internalized GH file?

[@ThirdDegreeGurn]

@@RhinoGrasshopper I've sent an email to the address provided on your channel!

[@estructurasguadua7383]

I don´t have the component EdgeLengths? I have Kangaroo 2 installed, Kangaroo and weaverBird. Where can i find this component?

[@RhinoGrasshopper]

You need download the latest Kangaroo 2.42 (Current version)

[@김채완-g6s]

마지막 결과물을 bake 했을 때 메쉬로 안 보이고 라인으로 보이는데 어떻게 하면 메쉬로 만들 수 있을까요?

[@RhinoGrasshopper]

Mesh가 Bake되지 않을이유가 없을텐데요? 마지막의 컴퍼넌트의 첫번째 아웃풋에 Mesh 데이터가 들어있습니다.