Thankyou i couldnt yet narrow down the words for what this item was but yes "Rudder Cable Fairings" now ive found it online ,thankyou soo much
@jayfromtexas67182 жыл бұрын
Never cease to amaze! Great idea!
@Aksmaniyak2 жыл бұрын
Thanks Jay!
@jayfromtexas6718 Жыл бұрын
Do you have an email address that you wouldn’t mind sharing? I have a couple of questions/ ideas I’d like to run by you, with pictures. If there’s a way to direct message on KZbin, I don’t know how to do it 😮
@rodneyhendrickson9811 Жыл бұрын
I was going to try and make my own plate This is going to work Great Thanks for the tip man
@Aksmaniyak Жыл бұрын
You are welcome Rodney.
@chrischase67312 жыл бұрын
Just ordered four of them from watching your video. Got 4 for 10.00 bucks.
@Aksmaniyak2 жыл бұрын
Nice. These are a much less expensive option than other cable guides for sale.
@kellycheesman45842 жыл бұрын
I like how clean this is. I just picked up a 12t and will be installing foot steering. My question is why did you mount on the top of the rail? Would it work as well if I installed on the inside on the side?
@Aksmaniyak2 жыл бұрын
Thanks Kelly. Yes you could mount it on the side but this was the best position for my set up.
@KyleLesmeister Жыл бұрын
Do you have the irrigation tubing going through the entire kayak hull from the entry to exit? Or just that little bit that you show on camera on each end? Thanks! Love the idea!
@Aksmaniyak Жыл бұрын
Thanks Kyle. The tubing runs the full length between the entry and exit points.
@EdTex76432 жыл бұрын
Great video, how did you cut the threaded section of the guitar jack?
@Aksmaniyak2 жыл бұрын
Thanks Craig. I put it in a vice and used a hack saw.
@MurrayWhitlockeJones2 жыл бұрын
A really neat solution. Do you know if the fittings are stainless? Figure they could well be if needing to handle sweat / skin contact on a guitar.
@Aksmaniyak2 жыл бұрын
Thanks Murray. Unfortunately, I couldn't find ny in stainless. They are painted/coated so if you wash off after salt use then they should last. They are cheap enough to replace if needed.
@BassManStrikes2 жыл бұрын
They have nickle and chrome plated ones for salt water use.
@helicopterjohns2 жыл бұрын
Nice re-purpose job!!!!!! Question? I think you may have cover this is a previous video. I would imagine that when you installed the brass tube into the nylon tubing you probably heated the nylon tubing a little on the end with a heat gun so when you pressed the brass tube into the mylon tube it flares the nylong tubing slightly and creates a nice flare on the end of the nylon tube. Love these videos. Keep them coming.
@Aksmaniyak2 жыл бұрын
Thanks John. I did cover the brass insert in another video but just wanted to do it again in this one since it was related. You are correct, heating up the tube makes it easier to insert the brass piece.
@타작2 жыл бұрын
👍
@Aksmaniyak2 жыл бұрын
Thank you.
@BassManStrikes2 жыл бұрын
Awesome 😀 Amazing how well they work for that purpose almost as if the guitar folks stole it from the boating 🌎 world hahah 😆