Great video advice. Removed washer jets, soaked jets in boiling water and white vinegar for about 30 mins, both now clear and washing windscreen like new.
@dank84895 ай бұрын
Thanks for the video. I fitted mine and it was too high and the water fired right over the back of the car. I just loosened off the screws to the washer fitting, moved the angle and tightened whilst holding in position and it seemed to have done the trick.
@beatenthepresspodcast Жыл бұрын
Great video. The wipers took a while up get off but some old fashioned elbow grease did the job.
@Simple_Slmon Жыл бұрын
Glad it was of help.
@whatsnew8280 Жыл бұрын
Brilliant vid but a few extra words and photos regarding awkward areas would of made it excellent
@Milchreislucker7 ай бұрын
Thanks. How do you adjust the jets higher?
@burtonfootballer54083 ай бұрын
Its not just the Kia garage that you mention its all of them. The 7 year guarantee is a massive con nowadays and to add insult to injury they dont have an appointment for nearly 4 weeks. ITS THE LAST KIA I WILL BUY. Anyway I am half way through the job and just wondered if you can actually take the nozzle jet apart? What actually blocks it or stops it working?
@Simple_Slmon3 ай бұрын
Debris in the water you use to fill the reservoir.When you fill up the washer fluid use a clean pot and clean water. You cannot take the nozzle apart.
@harviemilligan1887 Жыл бұрын
No idea why his Kia dealer said it wasn't covered by the warranty, I got my front and rear jets replaced under warranty just before my 2015 Ceed's warranty expired (I took it for its 7-year service a month early to ensure it was still covered). I was told the "pipes had collapsed". Also had to fit a new pipe coupling at the tailgate.
@m.tahiraslam4941 Жыл бұрын
hi, is this for Kia Ceed 2 or 3? I have 2013 model. You didn't show the full car from front, so can't tell. Thanks
@Simple_Slmon Жыл бұрын
Its not my car but I think it is a 2019 model.
@m.tahiraslam4941 Жыл бұрын
thanks@@Simple_Slmon
@aubs4205 ай бұрын
These wiper arms are stubborn… Tried every trick in the book. Can’t get anything under to lever on either!
@Simple_Slmon5 ай бұрын
Give them a tap with a small hammer, on the side, you could try a tiny squirt of wd40. Constant pressure wont work they need a yank. All wipers are the same.