Late night chip Install E34 525i 402 Red label DME

[@skipgray1543]

Thank you for the clear video! Made it easy.

[@radu197666]

I am stuck at 1:00 . No matter how much i played with those 2 plastic side tabs I just cannot pull out the top part in order to expose the chip . Lift it and pull it seems to be the procedure . Eprom chip ready to replace to stock one in my 1992 manual 325i non Vanos

[@keengarage1253]

Yeah that part is probably the most stressful. If you are certain the 2 black clips by the pins are released the issue is the board isn't at a steep enough angle. On some you have to push up much harder than you think is safe but, as soon as you get the right angle it will pop right out.

[@radu197666]

@@keengarage1253 I was able in the end to do it by just opening the 'jaw' of the 2 boards as i could not pull out the top board . My manual 91 325 feels a bit faster but it likes to rev more for the first minutes, it's like the computer needs to adjust to the new 'brain' .I felt more of a difference when I did that last year in my auto 92 525i - same non Vanos M50 engine , same EPROM chip - but when you gain 0.3-0.5 sec in 0-100km/hr it's obviously you'll feel it more in a 10 sec auto 5er vs a 7.9 sec manual 3er .

[@skidmeister]

Were you in the dark when you filmed this?

[@nawandyasen2409]

Great video, can someone please give me a trusted website to buy tuned chips? I'll be thankful

[@samualhill-simmons5614]

Ecs tuning is good. I just got a turner chip off there

[@kevinmosleyI]

Hahaha love it, the thing where you push straw around with a screwdriver is always fun! 😆 What chip was it? I just did a Turner chip on my non-VANOS green label; +20hp and 7,200 rpm rev limit- pulls quite a bit better...

[@WashJosh]

Is this the same car you replaced the head gasket on?

[@skidmeister]

Thank you for not mentioning to pull the back where the two boards connect and then pull it out. Please make more instruction videos.

[@keengarage1253]

Do you see the words "how to" in the title? No? Because it isn't one, I made the video for fun take it or leave it. 😙

[@420catson]

thanks for this man, is this on an m50 engine?

[@Kanat39]

Yes

[@piglipsv8adaptacoeseprepar697]

Do you have Instagram ?

[@keengarage1253]

@drsomers