Lawn Tractor Electric Fuel Pump Upgrade

[@busterbaker8820]

I've searched for hours trying to find 12 volts with the on. I finally found your video with explains it quickly and succinctly. Thanks

[@manny7684]

You can use a higher pressure pump. Just need to"t' into the line before enters the carb and return it to the tank

[@ben501st]

I've got one hooked up to a 12hp Briggs and a toggle switch. If the engine starts to flood, I flip the switch and let the bowl empty a bit.

[@toffeeavatar5011]

Great ❤, now I move on to modify my top heavy motorcycle 😂.

[@donens9310]

Confused. In your video you state that pump should be below 4 psi, yet the amazon link goes to a pump 3-6psi and a 2amp. Please explain. Won't this blow fuel by the needle valve?

[@dimitrimotor2861]

or you have to work with a return fuel line that drains a little higher, then you can put whatever in it and that will really work

[@greenmachine55]

Ive got a 19.5 hp i/c opposed twin briggs and stratton engine with a 4 screw nikki carb craftsman lt1000 manual is it possible to switch from the fuel pump on the carb to an electric fuel pump this is a carb that has no Solenoid the carb mounts on the intake

[@dgriffin6074]

My Troy Bilt riding mower has gravity fed fuel to carb. Once my fuel level drops below half a tank (tank is in front of firewall), it acts like it's got fuel starvation. Is it reasonable to add a low pressure pump?

[@trebsr]

Thanks for the link i just ordered one and thanks for the video

[@metalrooves3651]

My tanks all suck out of the top!How will l get gravity feed ?

[@andmk23]

Hi! Since I want to upgrade a diesel hatz on bolens 1225 with an electric pump, what I should do with the pulse pipe?

[@theredneck3673]

I did this but I used a Diesel pump and it worked like a charm it was to much pressure it would back fire wen u play with the Throdle

[@steveniesen3737]

I tried this with a 4 psi pump and am getting too much flow can I put a t and a valve

[@dgriffin6074]

You could add a fuel regulator which can yield a 1 psi pressure if u want.

[@jtothefx]

Gold ❤

[@josephssmai664]

Can this pump work on momo bake?

[@josephssmai664]

Can this pump work on motobake

[@shaunnightfire8269]

​@@josephssmai664Are you baked?

[@bobbailey9826]

Used 2.5 to 5 psi pump tried two both ran for 1 minute (clicking) when engine started clicking stopped and pump dead. Its a kholer magnum 18hp carburettor no line back. Any ideas whyvthe pumps are dying?

[@gregsr1]

found out most of the chinese pumps have to be isolated from metal to run.. had same issue mounted it to wood and then it worked.

[@metalrooves3651]

@greg frank why would that be?

[@gregsr1]

@@metalrooves3651 found no insulation between wiring and housing on the three i took apart.

[@rudygeorgiamulesandcountry1594]

I'm wrestling with this situation right now !

[@Novagunner]

Why would i go electric? more reliable?

[@manny7684]

Some pumps are cam driven that's why I did it. Cheaper than replacement for the Cam

[@kellymiller9273]

they ruin themselves because they run off the lifters which round out the fitting that makes them stop working