LCARA HAM Radio: Rohn 48' Tower Installation Part 2 - Hole & Concrete!!!!

Welcome to the Lake Cumberland Amateur Radio Association Club's KZbin Channel.
In Part 2, the lower large section of the tower has legs installed, the hole is dug and the tower section is concreted in the hole and leveled. Thanks to KI4RWO & KO4OSS for their time and expertise!
LCARA is an Amazon affiliate and using the below link(s) to make a purchase does earn LCARA a small commission to help with club expenses. Check our our ham radio related gear at our website: www.lcara.net/h...
Be sure to Subscribe, Hit the Notification Bell, Like and Comment on the video. We need everyone's support as we grow our wonderful club!
Support LCARA with your Amazon purchases. We are a 501(c)3 organization and can use your support. Go to smile.amazon.com, and register Lake Cumberland Amateur Radio Association with your Amazon account. It doesn't cost you more and sends a few nickels to the club with each purchase.
To join Lake Cumberland Amateur Radio Association you can email [e-mail]. You do not have to be local to our area and with Echolink, you can join in the fun on the Nets!
President - Don Munsey, AC4DM
2M Nets:
Sunday @8:30pm Eastern in the USA
Tuesday @8:30pm Eastern in the USA
10M Net:
Thurdday@8:30pm Eastern in the USA
Echolink - AC4DM-R
Kentucky DStar Net:
Thursday @5:00pm Eastern in the USA
Reflector 056B
Repeaters:
2M - 146.880 PL Tone 77Hz
70CM - 443.600 PL Tone 100Hz
DStar - 444.8375 Digital Voice (DV)
GMRS - 462.700 PL 118.8 (Please ask for permission to use when you are in the Lake Cumberland area)
Please visit our other social media outlets:
CHECK OUT OUR WEBSITE:
www.lcara.net
FACEBOOK:
/ lakecumberlandara
INSTAGRAM:
/ lcaraclub
#LCARA #hamradio

[@BVN-TEXAS]

You need to get that cement above the ground level to keep from water sitting on the legs and rotting them out.

[@barrykery1175]

36 inches deep? Oh My......I have the 56 foot version of that tower and I dug down 5 feet. My hole is 4 foot square and 5 feet deep. Barry, KU3X

[@robertheintz8017]

I know! Add to the fact that the soil is very loose and they didn't use any re-bar. I definitely won't be climbing that tower.

[@charlierumsfeld6626]

No cage of rebar or some other attachment to the tower through the middle of the concrete on the base? Just the 3 legs in a few inches of concrete at the perimeter of the yard of concrete?

[@glitter_fart]

a lot of it will depend on wind/ice loading but yeah ....... i'm going to be putting up a couple of towers soon and i'd rate this base as OK for a 40 foot tower for 10-15 years tops with no ice and max wind of 70 and a 2 foot windload.

[@chrisparker9886]

This guy does this for a living? Know way I would want him putting up my tower! 😳

[@nivid01]

“You should always wear a safety mask when mixing concrete so you don’t breathe in the toxic cement dust, but we didn’t use them because we didn’t buy any - and besides, Josh is an expert because he does this for a living using his pink handyman concrete mixer”. 😂

[@DeltaSierra181]

Do what the amish do, just pour the quickcrete into the hole and mix it with dirt, in time the quickcrete will soak up the water from the surrounding area.

[@tony.llainhart5907]

I wish we had some repeaters in east ky

[@mikem5043]

+1 on needing the top to be about 4" proud of grade. And wheres the rebar cage?

[@TheJagjr4450]

For my father-in-law's tower we poured a 4x4x4 rebarred with 3/4" studs welded to the rebar everything cemented into place for bolting down a 1" plate which I drilled and tapped for leveling bolts.

[@daveengstrom9250]

You are going to want to add more concrete on top of what you have there. The concrete must be above ground level for water drain off or those legs won't last long. You will need a lightening arrestor and a ground strap. Flat woven copper, not a wire.

[@James_Bowie]

That's what I call digging a hole the hard way. I prefer a generator and a hammer drill with spade attachment.

[@joewaldner6986]

Do you remember how many bags of Concrete you needed for this hole? 73

[@AvocaSingleTrack]

Where i live, that shovel would get abount an inch ...then it's all glacial drop rocks sprinkled with dirt ...

[@Thomas-sv6jr]

How did you keep it plumb while you were pouring concrete?

[@RadioTom103]

I don't have any experience installing towers, but from what I've learned, this is a very poor example of how to do it. No rebar, no levels, no extra grounding. Yikes!

[@jamess1787]

So you're telling me, in order to have the XYL approval: you need to purchase land for a second QTH? 😭

[@ederwin9189]

One cubic yard???

[@olivertaylor8788]

THOSE TIN TOWERS ARENT WORTH PUTTING UP..TO LITE AND FLEMSEY..IF YOURE GOING TO SPEND HOLE AND CONCREAT CASH,PUT IN A GOOD HEAVY DUTY TOWER..

[@KQ4LNZ]

man i need a tower like that 35ft maby

[@Zukuri620]

45ft would be better.

[@KQ4LNZ]

@@Zukuri620 I’ve got one now

[@Zukuri620]

@@KQ4LNZ how does it q9rk

[@nivid01]

Mate, as far as I can see there is not enough overlap where the black legs overlap and are bolted onto the actual tower structure. Is that Ken who wears an Hawaiian shirt to scale dangerous high towers? If it is the same guy, the so-called expert, then he should know how to pour a proper tower foundation, attach legs, and construct a safe tower!!!! But alas. But notwithstanding the above, your videos are well made and entertaining!!!!

[@rtoledo2]

Everybody is a critic . that is a crappy set up , those angle irons are straight , if enough wind hit that tower , that angle iron would pull straight out , those 1/4" round pegs welded are a joke. but i'm just a critic. hole is not deep enough

[@nivid01]

Mate, sometimes you and your colleagues stupidity on fundamentals amazes me. Amongst other things, the level of your concrete should be at least 100mm above the ground to protect from welling of rain water and corroding of the steel legs over time!!