Lecture 41 : Design of Batten Plates using Bolt Connection

[@hasanshirazi9535]

@14:41 We should round off at the step when we calculate D instead of d to make the section economical.Hence, a section of D = 270 mm will be sufficient instead of providing D = 300 mm.

[@nagnagesh-rv5mb]

Nyc sir

[@hasanshirazi9535]

@17:15 How did we get N = 2?

[@gautamraj-f7d]

We have taken 2 channel sections, so we will apply battenings at the front and back, so N = 2. If we have taken 4 angle sections and applied battening to that, then N = 4.

[@lokeshpanwar2863]

22:00 in connection what we take Anb or Asb??

[@jumasitauna11]

Sir, if we made ryy>/ rzz then in calculating c ...y did we take c/ryy when ryy > rzz ....arent we supposed to take the lesses radius of gyration

[@sourabhthakur90]

we need to find the minimum slenderness ratio which is corresponding to max radius of gyration i.e. ryy

[@prasadkhorgade]

Check is 800 it said that it is C/r min of individual member

[@ManojSharma-xy5yb]

In this question , from where the .53 value how we can find

[@ManojSharma-xy5yb]

In interpolation

[@ManojSharma-xy5yb]

In interpolation equation

[@gautamraj-f7d]

kzbin.info/www/bejne/eXe9qXxtfM2lrqc