Levi Wisby 351 PCM running Issues resolved

[@unclechucky7430]

Thank you for the video. Very informative.

[@hotheadzmarine]

Anything we can do to help. Thank you 🙏🏼🙏🏼

[@unclechucky7430]

I have a 1985 Cruisers Yacht 296 Avanti Vee with Dual PCM 351 W. Been on the hard for many years due to health issues. Finally bought a Trailer and brought her home. Now going to go through her with a fine tooth comb before I Sea Trial her. You brought up some good Maintenance items that I will be. Sure to address. Thank you!

[@hotheadzmarine]

@@unclechucky7430 GLAD TO HELP SOMWHAT. ENJOY 🏁🙏🏼

[@bjlee1988]

She needs some tender loving care! That oil hose you put the clamp on should drop right thru the drain plug at the engine - warm oil up, feed hose out the drain plug and let gravity do the work. A lot of hose clamps won't fit thru the drain plug hole, most use a shower curtain hanger to keep the hose above the normal oil level. Good video!

[@L3athaface]

Extremely informative video thank you! Quick question, where would you look first if there are low RPMs when you just put it in forward/reverse? I have the same engine and the RPMs drop to 150-200 sometimes even after adjusting the idle pin.

[@trentbrickley957]

My boat currently won’t go over 25 changed the water fuel separator, fuel filter, just about everything have u heard anything about this problem with this motor? I have tried everything and can’t figure anything out

[@trentbrickley957]

Also back fires then just won’t run above 25

[@hotheadzmarine]

I’m sorry, but that’s about a near impossible question to answer without having the watercraft in possession to check it. I would recommend you get it to a reputable repair shop and have them look at it.

[@golferdice]

You’re in limp mode

[@rickguthrie7662]

I have the same egine. Just replacedvwirh a rebuild last year snd rebuilt transmission and new, very high end, carburetor. Took it back at end of last year because of recurring problem. When cool, 1st start, i get rough dtart with lots of smoke. Then runs smooth and clean. After warm up, in gear, i can floor it, boat accelerates very fast. But st around 3,000 starts to miss between 3,000 and 3,500. Its hsrd to replicate in the shop? Could this be something called point bounce?

[@hotheadzmarine]

Sounds lik eit and cold start may be fuel or oil.

[@ericneering6357]

Yeah, I keep making the videos. He’s a great information to have when you have dreams of a yacht and you have a Robo income.

[@omgfroobynoobs]

Where are you located?

[@hotheadzmarine]

In Huffman Texas