Lexus LS460 Belt and Idler pulley Install / maintenance.

[@albertclark3801]

Thank you BnB for a great lesson on the LS460 serpentine belt and idler pulley install / maintenance. Clear lighting and diagrams very helpful. Appreciated!

[@BoltsNBoost]

I tried! Thank you!

[@ricardoruiz5533]

Hey man I got the same problem with the radio nipple I was trying to change the radiator fan and I accidentally hit of you can show me how to replace the radiator in your next video that will be great thank and keep up with the video your doing great

[@ImanAhole]

Since its easier to pass blame than take personal responsibility...YOU jinxed me on the radiator nipple I was tightening the big idler, and should have been more than fine with how tight I had it but went for 'one more check' heard a snap, exhaled and said "fuuuuuuuuhh' I knew immediately what had just happened. So I had a little tantrum, pushed my tool cart back in the garage, got on KZbin, made this comment and now I'm off to begin pricing a radiator on Rockauto. Thanks a lot BoltsNBoost Kidding about blaming you - not at all about everything else. I knew when I heard you say it that I was going to end up doing it cuz it's a 'me' thing to do...fuuuuuhhh.

[@BoltsNBoost]

LOL...love your comment....not your situation. Sorry to hear!!! We were both unlucky lol

[@saysimon9932]

I juat replaced my radiator... my bottom neck broke off... ordered a new pne from rock auto. 100 bucks.. been 3 month's and its been doing good

[@BoltsNBoost]

Rock auto is the way to go!

[@Infiniterian]

Hey man First of all, thanks for the video! I'm just wondering as to where you're getting the torque specs from. Thanks!

[@BoltsNBoost]

Hey! Thanks man. I got them from my mechanic buddy who has access to all data I think its called? Dealer stuff basically.

[@saysimon9932]

I have a belt sqeel . It comes an goes. I lmow iys the belt beacuse i sprayed it with belt lube and it goes away then cpmes back. So i know its not a bearing or pully.. belt still looks good and belt is still tight. I wounder if i should just do the belt change. Or maybe tensionier getting old and going out inermidaitely... what do you think?

[@BoltsNBoost]

It's hard to say, could be a dry belt, could be a tensioner or could be a bearing. I have had bad bearings that quiet down with spraying the belt