LOCTITE Flange Sealing and Gasket Demo by Richard Hoe

Are you experiencing leaky gaskets? Cut gaskets have surface irregularities that create failure points. They’re also prone to relaxation, displacement and flange bowing and deformation. Watch the demo video and let Richard Hoe show you how liquid gaskets perform better and longer.

[@calebbond3879]

Fantastic work Richard!!💪

[@hermesonferreira4442]

Show... Melhor melhor seria se fosse em português pra entender.... Gostei da demostração, irei indicar ao meu chefe pra solicitar a compra imediato....

[@GemmyHeart]

Main products: sealing gasket,gland packing,PTFE/graphite/asbestos products, ceramic fiber products, high temperature heat insulation and fireproof material. Free technical support (sealing, heat preservation, heat insulation, fire prevention problems) All products 1 piece can also be customized, 30 years of service experience, fast and safe shipping anywhere.

[@bennyrich7361]

7:42 that's why he is a happily married guy..

[@SandeepMorjat]

Can we apply it on valve cover gasket of a engine

[@Phiyedough]

I was looking for information on Loctite 5970 but I see it is not mentioned here.

[@bigdeal87]

Can we use 518 for valve covers ?

[@keithbennett1359]

I noticed that he used twice the amount of the required thread locker , about half of the outer bolt threads would never engage any threads , great for volume sales though .

[@ernesttrujillo7336]

Is Cast aluminum active

[@bewimotos]

aluminum carters would be consider active or non active metal?

[@gtirboost]

Fundamentally Aluminium would be considered an “inactive” metal here. That being said, Loctite have a range of “flange sealing/gasketing” products that are now considered “primer-less”. This means, they will still fully cure to a thermoset plastic on “inactive” metals. Take for example Loctite 518. You can still use the recommended “activator/primer” on “primerless” products, but this would be more so used to dial in a shorter cure rate based on the graphs found in the technical data sheet. For further information about specific application perimeters, reach out to a friendly local Loctite application engineer.... they are always more than happy to help give advice on product selection 👍🏼

[@bigdeal87]

I missed the primer on my aluminum engine do i need to re install?!

[@gbcautoworks]

I'm trying to figure out if the 5970 needs torqued up right away or is it finger tight leave 24 hours then tighten to torque? Timing chain cover on a bmw N47D engine