Рет қаралды 198
Todays video is a lost foam casting that I did to make a phone holder to use on a camera tripod. It was good to get the foundry fired up. I cast this using aluminum. I made the pattern using a presentation board that has the foam in the center of it. I thought it was a wasted cast because the sand I used was too wet and I added too much clay to try to fix it...so I got a lot of steam when i poured it and it didn't fill completely. But it did result it a usable part even if it isn't very pretty. Hopefully it will give someone inspiration about what is possible...and also show you what not to do too. Maybe I will do another pour to show you how it should look.