Low drag sprag and race upgrade for Ford C 6

[@joshpowell7113]

Thanks for sharing your builds! Ford content is always appreciated .

[@Dragracer64]

Your welcome ,and thank you for watching and commenting..

[@jglayden]

I broke mine trying to take it back out when it didn't seem to sit quite right. So since my original wasn't too bad, I just reused it and flipped the brass over so any wear was on the outside. Next one I do, I will try to get the original. I saw a video where that plastic just cage just tore up, so I am a little concerned with this anyway. But good video.

[@Dragracer64]

So far no troubles, but I wasn't impressed with what i saw while installing it. Time will tell. Thanks for watching.

[@bobcuomo5122]

great video thank you

[@Dragracer64]

Thanks for watching .

[@TheProchargedmopar]

👍💪

[@Dragracer64]

Thanks for watching.

[@the_fomoco_man5160]

Hello sir, just curious how the BW sprag and the new race with the Torrington bearing are holding up?

[@Dragracer64]

Still holding up.

[@0lddragracer426]

This video is still very useful, thanks by the way. Where is the best place to buy the Low Drag Sprag, and the Race Upgrade?

[@Dragracer64]

Found mine on E bay. This video is from about 3 years ago. I would have to dig deep into all my purchases , to find the link.

[@0lddragracer426]

Thanks for showing this video. I picked up some good knowledge. Where did you get the 4 pinion at?

[@Dragracer64]

Glad it helped

[@0lddragracer426]

I found it on eBay - $325. dollars. I have a GearVendors box for my 67' Ford pickup. GV says to use a 4.11 rear-end gear, so I bought a new one. After thinking about it, I thought...this is not a race truck your building on the street." "It's about 550-600 hp." "The lower ratio planetary would give me the out of the hole gear." "Maybe I should have bought a 3.90 gear instead, and I'd have even more cruising gear." What say you about this.

[@Dragracer64]

I have never own a gear vendors box , so I don't know how high the overdrive is. It all depends on what you want, as far as driveability, vs launching power. Also with that much horse power, if you run street tires, I am sure its going to spin a lot when taking off hard regardless of what the lower gear ratio is like.