Lure Building Part 2: Powder painting your jigs using a fluid bed

[@michaelloucks4448]

Hey Rick this is really great stuff I really enjoy watching your jig building videos. Thanks for teaching me this stuff in the long run it saves a lot of money building your own stuff. God bless you and your family.

[@canadiangemstones7636]

Wicked cool setup!

[@matthewfrey1948]

Nice setup. One thing I do is attach a squeeze clamp at the base of the heat gun so it can't tip over during the operation.

[@1MoreFish]

Great idea. I will start doing this as well!

[@djradrs199]

Nice Job.... I copied one similar to yours .🤟. I can't seam to find the those weed guard pins ... where did you find yours

[@markryan-k2x]

How did you attach the valves to the air chamber? I looked for a video of you making these and didnt see one.

[@prmvp]

Awesome bud! What size was the heat shrink tubing?

[@djradrs199]

1/8'' heat shrink.... check out sdg custom lure craft here on youtube look up his fluid bed w/ manifold build... super sweet set up... I only used 4 but copied his 8 cup design and put my pump position-to sit next to the cups on the board to keep it compact -- he's a very kewl dude does QUALITY WORK he also sells his stuff on his web site,,,,,,also he came up with a alum clamp system i copied for baking the jigs upright instead of hanging them very simple and if any thing drips it goes down the shank and no dimples on the head or paint in the weed guard 👊👍 tell hin Dan The Man Sent ya over 😎 #SDGCustomLureCraft How to Make an 8 Cup Fluid Bed with Manifold Regulator // Simple Design // With Pump Recommendation

[@Rubo7]

Awesome setup. What do you do when your fluid bed volcanoes and it boil properly? I have this issue on some colors(not all of them) but idk what to do to fix the issue.

[@biggybrocosta]

Nice set up! Where did you get your valves that thread into the base of the beds if you don’t mind me asking?

[@1MoreFish]

I believe I purchased these at Menards. But Home Depot should also have them.

[@jamesfrancisco7308]

Not bad just to many um's for me.

[@markinnis8404]

Just a friendly thought, start your own channel and keep the ums' out of your video!!😂😂😂😂😂 Have a nice day!