M.O.R.E. Shackle Reversal Kit Install

The M.O.R.E. Jeep® shackle reversal system or "SRS" allows the front suspension to travel in a much more natural action when the spring compresses. The new front pivot brackets are fully welded, and ready to bolt into existing holes in your Jeep's frame. This S.R.S.™ mounts the shackle "through" the frame. A hole must be drilled in the frame and then a tube welded in it, polyurethane bushings (provided) are then inserted into the tube and the shackles (provided) hang from each side of the frame. This method will not lift the Jeep®. The front driveshaft will need to be modified with a long travel slip in stub. It will work with or without a lift kit, spring under or over the axles. Works with stock 2" wide leaf springs only.
For more information on this and other Mountain Off-Road Enterprises parts, visit:
www.quadratec.c...

[@azneau28]

Could I install these if my front bushing mount is gone. Currently have a warrior kit up front but it was installed offset to the driver side and uneven in height. Could I just weld these to reinforce ?

[@nickphillips8682]

Yes i welded mine

[@yopyop3933]

Hello fellows..!!! What about a J20 ??? Do I need to go SOA ??? Or is there a Kit to gain some lift inches??? Someone did a perkins diesel swap in my J series, but the engine mount is to close to the differential " pumpkin"... Thanks.

[@offgridmangogrower]

Looking for shakle reversal kits for scout 2 and a early international ...?

[@sofiasauceda2856]

bideo too ohw instal 3" shackle rebers on 1997 ford f 250 diesel