maintenance and refresh Dewalt dcf899 MADE IN USA

[@TruthSeekerAi]

nice work thank u for sharing 1 luv Ameer/Reema nyc

[@billygray2472]

Man you do nice work👍🏼 thanks, just the video I needed

[@dalebassett6119]

What would cause my dcf899 to work but down on power

[@timothycampbell499]

Right on, good job

[@hishamhasim3828]

Thank you for the video

[@just1lifexx11]

Thankss for sharing your video.. mine need a tear down.. :=))

[@chrisbenavides7768]

What is the solution that you cleaned the parts with ?

[@Elgueroinks]

What is the solution you used to clean the brushes?

[@emmettturner9452]

“Brushes?” DCF899 is brushless.

[@zjedinite]

Intrested on knowing what solution he used as well. Alcohol? 🤷🏻‍♂️

[@Elgueroinks]

@@zjedinite I’ve learned that 90 percent iso works or you can use maf sensor cleaner if you have some on hand

[@emmettturner9452]

I would use something lint-free when wiping out the old lube.

[@emmettturner9452]

Not a fan of chewing new threads in plastic either! Seriously: Use a hand tool for putting the case screws back in and back each of the screws up until they fall into the old threads.

[@samand3845]

Hi! How to check engine separately?

[@ediliofarell589]

Y la grasa nueva para cuando estas armando seco se va estropear la maquina

[@emmettturner9452]

What were you marking with a Sharpie?

[@suratinsuratin9767]

Untuk dcf899 hp2 ndak mau hidup itu apanya yang rusak ya mister?.

[@blackmaria9242]

u dont put grase in spring and ball bearing hahah

[@WaitingOnToday]

Why not?

[@christopherthurlow1968]

You just had to skip how to take the casing off after taking the pin off come on man!!!

[@emmettturner9452]

??? I saw him take the casing off from start to finish. He removes the screws and pulled the casing apart… no cuts.

[@franklinwalker9606]

How old was this Dewalt ?