Make the Mobula 6 2024 Fly Better? | UAV Tech Micro Preset Testing & Review

After the slapping on the UAV Tech Micro tuning, the new Mobula 6 finally flies like it should. Much more control!
This is the UAV Tech channel: Please pay him a visit to support the good work.
/ @uavtech
Looking for lipos? Check out CNHL (Affiliated but no extra cost for you)
chinahobbyline....
Have some questions? Leave a comment below or message me at my IG account.
www.instagram.....
Want to support me? I am running this channel fully self funded and it is a LOT of work, so if you feel like want to support my channel to keep me going? Please subscribe and hit the like button Or please buy me a coffee! Thanks in advance!
bmc.link/iflyx...

[@shogunemperor]

Awesome bro!!!! Cool review of the 2024 mob6. Totally agree, It does drift a tad too much, personally, I kinda like the drift. haha Nice one man. Thanks for the recommended preset. Gonna go try it out.

[@iFLYXWings6589]

Thanks man !

[@Wind_Rapport]

Super straighforward video and instructions. Nice. Gonna try this out.

[@terrysouth7201]

I was so excited to get mine in the mail, but disappointed when I found that it flew far worse than my custom built meteor 65 with a stock tuning, thank you for doing this video

[@dalao9351]

did the same, but i increase master multiplier to 1.6 to make it tighter and got nice trace from blackbox

[@SampagaFilms]

this version has been nothing but dissappointment. I eventually returned it. It initially came with no video feed so I had to reflash. Then I also kept getting bad RX warning and would just drop mid air.

[@brandon9689]

How did you even get a return? HappyModel is ignoring banggood's return claim and burned me. It's been a week with no correspondence. This has been my worst experience to date since I started FPV.

[@180dividedby2]

same here, Bad RX issue

[@RandomContent6]

im having a hard time with this drone and is very stressful and camera cuts out after 1 minute

[@doodgeslagenmug]

My issue is that it just drops mid air at the start of the battery. Sometimes even during mid flight. It’s just very faulty and it’s too bad because i think it actually flies really well in terms of power to weight. Even the battery life is impressive, just the tune and the inconsistent units are what brings it down.

[@iFLYXWings6589]

Agree, i had incidents when it dropped during mid air, not sure what happen but it seems this tent to happen when the VTX is too hot causing something to fail safe, not sure about your experience?

[@kurtzFPV]

They shipped with 2 different gyros and I think the PID loop frequency is set wrong on some of them out of the box. One of the two I own was giving similar problems and I changed that single setting and zero issues now. Happymodel has the correct settings by gyro on the mob6 2024 page.

[@Junga1234]

Is this a decent start drone for light flying outside and inside?

[@iFLYXWings6589]

Yes

[@Junga1234]

@@iFLYXWings6589recommend any particular websites to order from if in NA?

[@iFLYXWings6589]

@@Junga1234 AliExpress is still the best bet

[@SampagaFilms]

Don’t get this version, you will regret it. Get the mobula 7 instead

[@RandomContent6]

I got it

[@brandon9689]

Mine is not even 2 hours old I barely finished configuring flight modes and video feed is already gone. Gray screen, with OSD but no video feed. I'm absolutely flabbergasted at how junk this is. I've already put in for a return, I don't even know if I should bother exchanging. There's no way content creators and reviewers got the same batch as regular customers.

[@iFLYXWings6589]

Sorry to hear that, seems like either the camera is broken or wires are loose. This particular mob 6 is a bit problematic, good performance but not as good quality. Yes, returning it is another option.

[@brandon9689]

​@@iFLYXWings6589 return isn't even an option. Refused by HappyModel, I'm stuck with it I bought a runcam nano 3, I'm doing a few practice runs before I try soldering it in. Super disappointed with this, and HappyModel's response.