Manual Rollsizer - HAND Operating

[@caleblong3184]

Hey Calvin. Thank you for posting. What hopper are you using on that rollsizer ??

[@calvin14888]

Hopper?

[@caleblong3184]

@@calvin14888 where you put the brass

[@calvin14888]

@@caleblong3184 www.doublealpha.biz/ca/mini-xl650-case-feeder

[@caleblong3184]

@@calvin14888 thank you 👍🏻👍🏻

[@aaronweber4775]

Is the manual constant cranking tiring fairly quickly? I realize that is very subjective based on conditioning but just wondered if you would get the manual again or spend the extra money and get the motor?

[@calvin14888]

Frankly it gets tiring if you rotate the crank fast, with normal speed it's ok. But that's a easy fix as I'm using a two speed drill now and use the slowest speed possible but set to high torque will do the job. Check on my other video on my channel you'll have an idea. And it came with the drill adaptor with the rollsizer now. With the use of the drill I can achieve a faster rates I'll say I would get the manual again to save my cost. A drill only cost me $80.But be advised that the DAA case feeder is not included with the rollsizer it cost about USD45 from www.doublealpha.biz

[@fellas123456789]

@@calvin14888 , so the roll sizer comes with a drill adapter?

[@calvin14888]

@@fellas123456789 Yes if you buy it nowadays from them, it didn't come with it when I buy. But it's only a normally adapter you can buy from any hardware store for a few bucks. Check with my other video.