Mechanic States BAD Chevy Steering Shaft

Mechanic states bad Chevy steering shaft. Silverado, Suburban, Avalanche, Tahoe, GMC Sierra. steering. Chevy truck steering noise fix.
**Disclaimer: Matt's Shop shall not be responsible or held liable for any property damage, injury, or financial loss, costs, or expenses that may occur from the purchase or use of the products featured in this video and or attempting to duplicate repair procedures. This is for entertainment purposes only.**
#shorts #mechanic #customerstates

[@MattsShop]

FULL VIDEO: kzbin.info/www/bejne/gJeyhJqAeZt1qNk

[@christianclements61]

NO....The best way is to replace these parts with Doorman parts. Grease is a temporary fix at best.

[@livedsemoc3632]

Add a grease fitting and it will last a lot longer.

[@KevinPDunn]

Did you charge someone for that?

[@thesaabisturbo]

Lmao.. grease on the outside of the shaft won’t magically get on the inside of it, you can slide it out as far as it will go, and then climb under the dash to grease the inner shaft up.

[@user-jj8rt1br3f]

And my 2008 Chevy LS that I bought you from Facebook I replace the steering rack and pinion couple weeks ago and I just did the steering shaft the other day just replace all the parts I've needed to be more safe

[@user-tu7rr1zg4b]

Is the k2500 the same steering as the c1500?

[@dansexitstrategy5042]

Just replace it. Otherwise you will have to grease it again in 5k miles

[@blackwolfalch]

Just Chevy things

[@MeachPango]

I replaced my intermediate shaft with a dorman replacement. And theres not a clunk in the steering when i accelerate. Ive also replaced the steering bearing... any ideas?

[@LosAngelesChepes]

Lower shaft u joint by gearbox tends to clunk as well.

[@dante04srt]

Replace the lower steering column bearing at the same time as the intermediate shaft. The lower shaft doesn't really need to be replaced unless the ujoint is bad. It doesn't usually contribute to the clunk like the other two parts.

[@MeachPango]

@@dante04srt I did that at the same time. It wasn't doing it before I replaced the intermediate shaft(as it was the old clunky design) and bearing.

[@extrememiami]

This doesnt make any sense. I bet you got grease accidentally on the U joints.

[@beeswax2182]

It worked for 2 weeks at most

[@joseontiveros9057]

👍✌️😎